20 Most Recent 1992 Chrysler Lebaron Questions & Answers

0helpful
1answer

Where is the fuse for the ignition switch battery feed, wire on the 7 wire plug under the steering column

Check fusible links. Hopefully one of your positive battery cables will go to fusible links. My wiring diagrams for your model year, aren't very good. bbbind.com has some wiring diagrams.
12/29/2017 11:16:32 PM • 1992 Chrysler... • Answered on Dec 29, 2017
0helpful
1answer

Transmission slip?

IS it due for a service? That's where I would start, As it just sounds like bands are starting to slip.
7/23/2017 11:53:55 AM • 1992 Chrysler... • Answered on Jul 23, 2017
0helpful
1answer

Car misfires but doesn't stall once it has warmed up

Yes friend, that misfire is just that. Called a dead cylinder. Could only be a dirty or faulty injector. Do a ohm-meter test on the unplugged injectors and a compression test on all cylinders with all plugs out if you don't find a faulty injector. Could then be a faulty exhaust valve needing attention.
7/15/2017 7:01:24 PM • 1992 Chrysler... • Answered on Jul 15, 2017
0helpful
1answer

Shifting problems

Check for cracked vacume lines first. The trans shop should be able to get or make a new wire harness and plug it in.it shouldnt be real expensive.
5/7/2017 1:29:20 PM • 1992 Chrysler... • Answered on May 07, 2017
0helpful
1answer
0helpful
2answers

Convertible top doesn't work

My 92 LeBaron top quit working but we can still operate it manually. You just need someone on each side to manuever it.
6/26/2016 7:54:44 PM • 1992 Chrysler... • Answered on Jun 26, 2016
0helpful
1answer

What clip removal tool to remove headliner?

1/23/2016 7:07:18 PM • 1992 Chrysler... • Answered on Jan 23, 2016
0helpful
2answers

1992 lebaron turn signals don't work but flashers do

find and change the turn signal flasher. it looks the same as the e-flasher.
11/18/2015 5:49:30 PM • 1992 Chrysler... • Answered on Nov 18, 2015
0helpful
2answers

How do you put a timing belt back in time after it broke?

Well, hopefully the valves were not damaged when the belt broke, If no valve damage was done, get the engine/crankshaft to top dead center, line up camshaft sprocket to timing mark and install belt around pulleys, gears, replace water pump if needed, tension belt if no automatic tensioner is used, try to start to see if it runs and hopefully it will. Might be time for an engine if valve damage was done. If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2496c4f07ad24453
6/13/2015 9:17:37 PM • 1992 Chrysler... • Answered on Jun 13, 2015
0helpful
1answer

I have a slow battery drain on a 1992 chrysler i o d fuse

Disconnect the below circuits one at a time to check. My bet is the power locks. Radio Heater blower Folding mirrors Central locks Interior lights The power seat
5/3/2015 4:10:10 AM • 1992 Chrysler... • Answered on May 03, 2015
0helpful
1answer

What all is on a iod fuse

DIYer? I recommend a repair manual from your auto parts store, or try filepeep.com or manualslib.com. You may be able to search Google images for a picture or diagram.
5/3/2015 12:37:01 AM • 1992 Chrysler... • Answered on May 03, 2015
0helpful
1answer

Drain plug on 1992 chrysler lebaron

water drain, lower edge of engine block just above the oil pan surface nearer to back of engine, and is lower portion of side of radiator oil drain, lower portion of oil pan torque converter drain, found through a round cut out in flywheel you must specify what you are wishing to drain
3/24/2015 3:21:02 PM • 1992 Chrysler... • Answered on Mar 24, 2015
0helpful
2answers

Wiper fuse keeps blowing

check wiring for short (water in the wiper connection) or for jammed wiper operation stopping the motor from working
2/12/2015 10:38:32 PM • 1992 Chrysler... • Answered on Feb 12, 2015
0helpful
1answer

Why am I hearing a low pinging sound in the rear/left suspension in my 92 Chrysler Lebaron when I turn?

I think your problem is in the wheel bearing. It needs to be replaced or just adjusted. GOOD LUCK FRIEND.
1/19/2015 8:50:17 PM • 1992 Chrysler... • Answered on Jan 19, 2015
0helpful
1answer

Why am I hearing a low pinging sound in the rear/left suspension in my 92 Chrysler Lebaron when I turn?

Its probably the shock/ strut.. i never worked on one of them cars but usually you can take rear shock/strut out through back seat or trunk. You have buy or rent special tool to keep the spring compressed when taking the strut apart.
9/16/2014 11:02:43 AM • 1992 Chrysler... • Answered on Sep 16, 2014
0helpful
1answer

Where is my heat sensor located on 92 chrysler

this should be it but car has 3 different motors this the most populer
9/15/2014 5:29:27 PM • 1992 Chrysler... • Answered on Sep 15, 2014
Not finding what you are looking for?
1992 Chrysler Lebaron Logo

238 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LeBaron Chrysler

  • LeBaron Chrysler

Most Popular Question

replace radiator

  • Cars & Trucks
Loading...