20 Most Recent 2006 Audi A6 - Page 4 Questions & Answers

you need to control them with the scan tool

take vechicle in for service you need a scan tool to reset service light.

Maybe The Volume Is Down But If It Is Not Try Buying New Wire Cables To Hook To The Speakers Or Install Built-In SpeakersKevin.

The rear seat pulls out easily.  Grab the front of the seat with fingers under seat on driver side and pull up hard.  do the same on the passenger side and it will unclip.  Then you can move the seat around to get to the buckle.  Install by inserting rear end in first and lineing up the metal tabs w/ the female plastic inserts in the floor and push down hard until it snaps into place.

Thanks for choosing FixYa. Have you checked your starter wires? Sounds like it may be loose. The bump could have knocked something loose. Do you still have power?

The code reader I have gives me the description to the code being displayed and as you said Midas checked it, they should have given you a description also.

No solution, same problem, but had many strange moments: 4 months ago during 100 kms or so it stopped, then suddenly came back, and worked ever since. A few days ago, it started happening again: NAV stuck, then radio dead, and gradually the rest disappeared. I did a Reset, and since that moment I see the intro-screen and then it goes black. Hitting the TEL button is somehow also a Reset...

Do the previous 2 posters have anything to report on this matter? It would be VERY welcome!

Thanks,
Jeff

The MMI get a momentary supply on switch on and the power seems to cutt off in time. This seems more related to a hardware issue, sometimes it can relate to a poor linking cord connection or a cord connector. Also it can be fault in the MMI or the interface power.
If there is malfunction seen in the performance then it relates only to a display issue. Sometimes it can be due to component weakness- look out for faulty capacitors in the MMI.
Ideally the fault can be confirmed after a check up for loose joints/connections. If not it need to be swapped with a working unit before being replaced.