2003 Jeep Liberty - Answered Questions & Fixed issues
Jeep liberty transmission problem
IT COULD BE SOLENOID PACK OR THE GOVERNOR AND TRANSDUCER OR LOW FLUID OR THE MOST COMMON REPAIR SPEEDS SENSORS INPUT/OUTPUT. ALL OF THESE CONTROLS THE SHIFTING. START WITH THE SENSORS FIRST, VERY COMMON.
12/28/2021 1:15:49 AM •
2003 Jeep...
•
Answered
on Dec 28, 2021
•
6,279 views
2003 Jeep Liberty water pump pulley
Most water pumps come with a pulley already fitted. Replace the entire pump and pulley as the pump blades are plastic and wear over time. Most vehicle manufacturers recommend changing the pump everytime you replace a timing belt. If you are removing the belt to do this job swap the timing belt for a new one. Always a good idea on older and higher mileage vehicles.
11/18/2021 7:32:39 PM •
2003 Jeep...
•
Answered
on Nov 18, 2021
•
86 views
Donde esta el sensor de velocidad jeep liberty
Sin duda es tan probable una solucion como la otra. En algunos casos no hay cambios ni con el sensor nuevo, Lo que nos vemos en la necesidad de hacer es desconectar un cable de la bateria y aprensar la bocina del pip para que descargue toda la energia electrica que pueda tener en los sensores, y hacer review de esa manera a funcionado, y empieza de nuevo como cuando era un Jeep Bebe. Saludos. Y no deseo contradecir a nadie pero por favor corrijanme en mi jeep el sensor de velocidad no esta frente al radiador, quizas exista una confucion de mi parte pero lo localizamos en la bola trasera de la trasmicion en la parte de arriba. No tengo intencion de contradecir a nadie. Quizas estoy en un error os pido disculpas si asi es. pero intento hacer lo mejor . Saludos. y gracias/
6/18/2021 9:46:45 PM •
2003 Jeep...
•
Answered
on Jun 18, 2021
•
1,593 views
Clunking in rear end Jeep Liberty 3.7 automatic
Nearly impossible to tell you what it is without actually hearing and seeing it. I recommend that you check the rear universal joint, pinion bearing and wheel bearing assemblies for looseness. If it's that loud it shouldn't be too hard to find.
Good luck!!! If you need help doing the repair or have other questions just ask!!!
6/18/2021 6:54:52 PM •
2003 Jeep...
•
Answered
on Jun 18, 2021
•
1,685 views
Broken screw thermostat
If you can remove the thermostat housing and the bottom bolt is visible, you can use a vise grip to remove it.
If the bolt is broken even with the block, then you have to drill it out.
6/6/2019 12:49:29 AM •
2003 Jeep...
•
Answered
on Jun 06, 2019
•
923 views
Sluggish take off
Fuel pressure ? Bad tps switch? Have a scanner hooked up and see what is not working when this happens. Better than guessing.
4/24/2019 5:46:17 PM •
2003 Jeep...
•
Answered
on Apr 24, 2019
•
112 views
Wheel Bearing Niose?
Lift the tires off the ground and spin them and check for any play in the bearings. Look at your tires. If they have flat spots on the outter edges of the tire then that is probably the noise you are hearing.
4/19/2019 7:12:22 PM •
2003 Jeep...
•
Answered
on Apr 19, 2019
•
262 views
Have a 2003 Jeep Liberty
Sounds like a ground problem allowing a back feed issue.
Make sure your battery is grounded to the engine and frame.
3/9/2019 1:03:18 AM •
2003 Jeep...
•
Answered
on Mar 09, 2019
•
177 views
Not finding what you are looking for?