Top 20 2000 Jeep Cherokee - Page 3 Questions & Answers

The dealer can do that for you.

posted here 100 time. http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service WJ. all cars have spare conn,. and fuses. for options not opted. they do not make a harness for all 100 permutations of options that would be crazy. no its not SAFE pull the neg, lug on battery before any PDC work. or take the risk of eating acid or far worse. "BOOM" if you work on a car, the FSM is the bet book. its all there, just read it.

I need to know exactly what they intend to do on the engine, you are just to vague.

FSM. its all there. or try alldata.com if doing DIY and are serious. get serious books, or get alldata. or at mitchels, both have DIY page. most cars its in the fuse box.

Low beams ARE your headlights. If they don't work--replace them both. Simple as that. Remember if one burns out, the other is soon to follow.

Hi Paula, You didn't mention if you changed the plug wires. You mentioned replacing the camshaft sensor. Have you checked the Crankshaft Position Sensor? Or the Mass Air Flow Sensor (may need cleaning)? Or the Throttle Position Sensor?

You never replace any parts until you properlytest them & they fail a testYou need wiring diagrams to know where yourtest points areCan't do anything to resolve any electrical issuewithout the use of a volt meter

operators guide. lost, ask jeep for this guide, get one.... here is the full fsm. DL this and burn to CD or mem.stick. bingo, ready to rumble any time any place. http://www.xjjeeps.com/pdf/2000_service_manual.pdf

which engine, its an A/T tranny right? my jeep is a stick, both.. fails hot and cold engine, (bingo huh?) never go backwards again. pretend its an old harely... lol are all other things perfect? drives perfect, lights work. all? check fuses first. clean ISC, valve. clean EGR valve. give it a tune up, if yo skip those.... do you, every 60k?miles?

check fuel pressure and spark whats missing if door buzzer not workinh unplug crank sesor see if it starts working no buss will be in the odeometer

why not scan it the CEL glow to say, please scan me, i have errors. in 2000 year cars, the PCM reports all TCM errors. they are unified. so scan it, what is the delay there, ???? do , get it, or at the least autozoned scans (kiddy scan) get the real DTCs dont let the kid blabber, "that bla bla is bad" if he knew what was bad, he'd not be a clerk.

double posted, back up one.

you have to decide that the hood could get warped or blow up over the windshild

check make sure all hose clamps tight could have leaking thermostat O- RING or gasket.check make sure water pump gasket not leaking.

no question posted. the above is statement. 1: how to test test it or diagnosis it. how to replace. how to buy it. how to torque it/ what tools.? see>, a real question. works best.

Low pressure switch or clutch switch if assuming clutch is not engaging when cold air is not being supplied.

check all your ground wires and look make sure no wires are pinched between head and block also check the distribitor for wear wobbling around in side of it

have fuel pressure tested

P0240 Turbocharger Boost Sensor B Circuit Range/Performance