20 Most Recent 2000 Jeep Cherokee - Page 5 Questions & Answers


P0441
Evaporative Emission System Incorrect Purge Flow
P1494
Jeep: Leak detection pump pressure switch or mechanical fault
U either have a leaking fuel system or the pressure sensor at the gas tank is defective, I would replace the pressure sensor 1st.

2000 Jeep... | Answered on Oct 25, 2013


buy a Haynes repair manual at your local auto parts store it will be a great investment for you

2000 Jeep... | Answered on Sep 18, 2013


P0240 Turbocharger Boost Sensor B Circuit Range/Performance

2000 Jeep... | Answered on Sep 18, 2013


You never replace any parts until you properly
test them & they fail a test

You need wiring diagrams to know where your
test points are

Can't do anything to resolve any electrical issue
without the use of a volt meter

2000 Jeep... | Answered on Sep 14, 2013


you may want to check your water pump it sounds like it may not be circulating. you may have a blockage somewhere but its un-likely...also make sure the thermostat was installed correctly and it was for the correct temp to open 205 degrees F is good. lastly check to make sure there is no coolant with your oil , or vise verse. good luck hope you find out why.

2000 Jeep... | Answered on Aug 22, 2013


Low reverse sprag is broken

2000 Jeep... | Answered on Jul 23, 2013


Does the leak show up on the ground when you are parked with the engine running or stopped.
Determine where it's leaking from. Hose? near fire wall, near radiator. Water pump will leak when it's worn.
Can you smell it when you're inside the car? heater core.

2000 Jeep... | Answered on Jun 10, 2013


Hi there:
Check this about PDC...
0db3e77b-bcb3-4440-a80c-76be40973418.gif
63367f59-9c84-49bf-897c-680b75f4eca4.gif
The high-current fuses are coded as follows:

4980b21b-8781-4c60-80bf-6f48b8749e08.gifc3aee5f4-38e9-4b75-b973-4ce8679aeb4f.gif864fff7e-da01-4f5a-8d38-a86301767c7b.gif
Hope this helps.

2000 Jeep... | Answered on Apr 30, 2013


My 2003 Jeep Grand Cherokee Laredo, It slips when i turn left all the time!!! What is that??

2000 Jeep... | Answered on Apr 29, 2013


I am going to assume that it will not run even if you push on the accelerator pedal?
Can you install or attach an old timing light to the spark plug wires, turn it one and try to start it. The light should flash with the engine running, but if it shuts off at time of engine die, and the engine is still spinning, you are losing spark, My suggestion is the cranks shaft sensor on bell housing.
Second, install a pressure gage on the test port on the fuel rail and watch it as you start the engine, fuel pressure should not drop as the engine dies, if it does, the pump is not working correctly. There are two modes of power to that pump, one to start and timed, for only a few seconds to prime the system, and one to run continuously. Find the wires going to the pump at the tank. Connect test light to those wires and watch what happens during crank and at stall, You should not have the pump shut off and the engine dies.
If you have spark, and fuel pump working, when did you last change the filter,,but I put that LAST.
It has to be one or the other of these.
Good Luck

2000 Jeep... | Answered on Apr 04, 2013


Check your grounding strap from the frame to the block if ti is not grounding or it is not in good shape it will not charge the battery

2000 Jeep... | Answered on Mar 28, 2013


Broken valve spring or hole in piston youd know the piston cause you would hear it pull the valve cover and take a good look make sure all is well. might have oil dripping in from valve if spring is broken or weak and not closing all the way you do not have to pull the head to check this just the valve cover and check the valve seals they may be rotted do the small stuff before pulling the head. use a good flashlight and take a good long look with rags in hand go over all the sufaces around the area in question you may have a crack hope not but do a good check of the area did i say do a good check of the area ok

2000 Jeep... | Answered on Mar 28, 2013


get used ecu from wrecker and switch out and c if that works

2000 Jeep... | Answered on Mar 25, 2013


crank shaft sensor just had this prob its located on top of trans

2000 Jeep... | Answered on Mar 24, 2013

Not finding what you are looking for?

902 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Cherokee Jeep

  • Cherokee Jeep

Most Popular Question

sentry key light 2000 jeep cherokee

  • Cars & Trucks
Loading...