2006 Cadillac DTS - Page 7 - Answered Questions & Fixed issues
Were are spark plugs located on 2006
the plugs are under the coil packs.There are 2 coil packs on top of each cylinder head.Just remove bolts on the coil packs and pull up.You should be able to see the plugs.Hope this helps.Good luck.
How do you change the headlight bulbs on a 2006
you should have to go thru under the hood to the backside of the lamp assembly. There should be either a hard plastic cap or a plastic dust cover that has the wires going thru it to the lights. If it is the hard cover (looks like a jar cap) turn it 1/4 turn counterclockwise and pull it out of the way. Take the bulb/socket out. Unclip the old one- Put the new one in. (DO NOT TOUCH THE GALSS PART OF NEW BULB). Then re-assemble
3/11/2010 8:42:21 PM •
2006 Cadillac...
•
Answered
on Mar 11, 2010
•
1,164 views
What causes the fuel pump fuse to keep blowing?
A fuel pump is a kind of motor and any motor is subject to having shorted windings.
If the shorts weren't catastrophic, the pump could still be functional but drawing much higher currents than when built.
I have an ugly feeling your fuel pump in located inside your gas tank which would require removing the tank to replace it.
I'm pretty sure that the real factory service manual would have a test (resistance measurement) that would quickly find whether the pump is healthy, whereas the aftermarket books from Haynes or Chilton may not.
How to change spark plug on 2006 cadillac DTS
The plugs are located by engine head. You can use a ratchet wrench and sockets to remove them. Make sure to mark the plug wires so the order doesn't get mixed up.
The check engine light comes on when there is a bad sensor, or bad circuit.
Many part stores will run an engine diagnostic code scan for free which will pinpoint exact problem that is setting of the check engine light
The light can only be shut off by the diagnostic scanner!!
11/23/2009 4:44:29 PM •
2006 Cadillac...
•
Answered
on Nov 23, 2009
•
1,328 views
Shimmy in hard braking
The break roters either need to be turned (shaved down to smooth) or replaced.. When the roters get warn - the slightly worp thus causing shake or shimmy when breaking..
How to remove head light in 2006 dts cadillac
ok, In this New of a vehicle there are no screws holding the headlight in if you just need to replace a headlight because it is burned out. Look at the back of the light where the wires attach and you should see the wires going into what appears to be a coupling. Get a hold of that and turn. After it unlocks you can remove and replace the bulb. If you are replacing the Headlight assembly because it was damaged there are typically 2 long scews on the top front that appear to be adjsutment screws and 2 smaller ones in each side, again on top. Good Luck
8/27/2009 3:55:03 PM •
2006 Cadillac...
•
Answered
on Aug 27, 2009
•
1,130 views
Not finding what you are looking for?