20 Most Recent 2002 Cadillac Escalade Questions & Answers


hello
u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable -store and it;s actually really illustrative

2002 Cadillac... | Answered on Feb 19, 2019


Most likely a bad unit. You will need to get a new one, from a junk yard as they are probably expensive at the dealer.

2002 Cadillac... | Answered on Jan 15, 2019


We're is a starter located on a 2002 Cadillac Escalade

2002 Cadillac... | Answered on Oct 27, 2018


The clicking from the front can be two things. 1.Is the cv joint as you are saying if it is front wheel drive witch it is not. 2. The most likely thing that you are hearing is a front wheel bearing. I would have the front wheel bearings checked and replaced if needed.

2002 Cadillac... | Answered on Jul 12, 2018


are you talking about brake fluid --power steering lines do not connect to the brake system --- also their is no weep hole at the bottom of the brake booster ---can you please clarify what is leaking and where --power steering lines from pump to radiator to steering rack ----brake booster mounted to fire wall with brake master cylinder bolted to front

2002 Cadillac... | Answered on Jul 12, 2018


Only the rear ones should have the air lift feature, although there is a conversion kit that may have been used to add air lift to the front.

The type of shocks you have (front and back) will depend on whether you have the Electronic Suspension system option. Without this, the shocks are pretty standard. However, if you have this, they are all (front and back) controlled electronically to adjust the firmness of the shocks to assist in keeping the vehicle level during maneuvers. You can quickly tell if you have this option by examining one of the shocks to see if there is an electrical connection on the side. If you have this system, these can be very expensive and hard to find, and GM has had a lot of trouble with them. As a result, many owners have replaced them with standard aftermarket struts (which includes air lift versions for the back). However, the old shock electrical cables have to be specially terminated if you do this (see The Cadillac User Forum for more info).

2002 Cadillac... | Answered on Jan 16, 2018


bad battery or connection in starter cables.

2002 Cadillac... | Answered on Dec 11, 2017


Check your starter. Your silinoid may be getting stuck when u turn the key forward.

2002 Cadillac... | Answered on Dec 04, 2017


Also check the 30A RTD FUSE in the underhood fuse block and the 10A IGN 3 FUSE in the left I/P fuse block. After that, there are myriad other things that could be at fault.

2002 Cadillac... | Answered on Nov 20, 2017


BCM has nothing to do with this function , MMM - memory mirror module !
Memory Mirror System Operation
The MMM is capable of storing mirror position for 2 different drivers. Mirror position is determined by both horizontal and vertical position sensors in each of the power mirrors. The MMM supplies a reference voltage and a low reference to these sensors and determines mirror position through the horizontal and vertical position signal circuits.
The MMM receives power through the battery supply voltage circuit and the MIR/LOCK fuse and a constant ground source. Any time that battery voltage is disconnected and then connected from the MMM, the MMM will enter the mirror relearn mode. The mirror relearn mode can also be commanded using a scan tool. Refer to Memory Mirror Module Learn for further information.The memory switch receives power through the battery supply voltage circuit and the MIR/LOCK fuse. The MMM upon receipt of a memory switch signal input, a class 2 message from the SIC or a class 2 message from the PCM indicating that the transmission is in park, will then supply battery voltage and ground to the appropriate power mirror motors through the mirror motor control circuits to move the mirrors to the predetermined positions.

DTC B1586, B1596, B1616, or B1626
The mirror horizontal and vertical position sensors are potentiometers. The Memory Mirror Module (MMM) provides these sensors with a 5 volt reference circuit and a low reference circuit. The MMM monitors the horizontal and vertical position sensor signal circuits which change values based on mirror position. These voltage values are used to determine mirror position and can be set into memory. When the MMM receives a memory recall request, the MMM will control the power mirror to the memory position based on the horizontal and vertical position sensor signal values.

Install a scan tool.
Turn ON the ignition, with the engine OFF.
With the scan tool, observe the mirror horizontal and vertical position parameters in the Memory Mirror Module (MMM) data list.
Operate both the left and right mirrors through the full range of movements.
Does the scan tool indicate that the left and right mirror horizontal and vertical position parameters are within the specified range?

Memory Seat System Components
The memory seat system consists of the following components:
• Power seat switch assembly
• Memory recall switch assembly
• Horizontal adjuster motor
• Front vertical adjuster motor
• Rear vertical adjuster motor
• Recline adjuster motor
• Memory seat module
• Memory mirror module
• SEAT 25A circuit breaker
• MIR/LOCK 3A fuse

Your best bet , take it to a qualified repair shop !

2002 Cadillac... | Answered on May 23, 2017


If you think the dealer caused it get a hold of GM district rep .Talk to the service manager . If the dealer Technician's can't fix it , get the factory involved . In most cases if it is something they did they need to take care of it ,free .

2002 Cadillac... | Answered on May 06, 2017


Could you explain that a little better ? When you push the up switch for driver's side window ,the window goes down ? Bad window regulator . That would make sense , you probably open an close that window more .

2002 Cadillac... | Answered on Mar 19, 2017


here is a video that shows how to do it.


I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

2002 Cadillac... | Answered on Oct 06, 2016


Check cv joints

2002 Cadillac... | Answered on Jul 05, 2016


On an MGB, that usually means a rear main seal - (around the crankshaft). Not a quick fix, must separate engine and tranny to install a new one.

2002 Cadillac... | Answered on Apr 03, 2016


I think i know what the issue is i had the same problem. It has to do with the security system failing. i found a site that sells a module that will bypass it and allow your car to start every time. You can even install it yourself. It is also guaranteed . If it doesnt work u can send it back. I did mine 5 years ago and i haven had an issue since. Your car is on the list for this problem. Check it out i hope it helps ya http://vatspasslockpasskeysecurityhelp.yolasite.com/

2002 Cadillac... | Answered on Feb 17, 2016

Not finding what you are looking for?

507 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14053 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Escalade Cadillac

  • Escalade Cadillac

Most Popular Question

2002 cadillac escalade no sound from

  • Cars & Trucks
Loading...