20 Most Recent 2006 Pontiac Vibe - Page 8 Questions & Answers

Regardless of engine orientation, transverse (front wheel drive) or longitudinal (rear wheel drive), the starter is always found at the junction of the engine and transmission bell-housing.
The starter drives a ring gear located within the the bell-housing and is normally bolted with 2-3 long bolts.

CODE P2716 NOT IN CODE BOOK.

somebody has pressed hard with a finger,the only solution is a new unit,sorry.lcd screens are sealed units.

have the code checked especially if the car is out of warranty. If it is still under warranty take the car to the dealership . The Pressure Control Solenoid determines the quality and accuracy of the shift points and if you let it go the transmission will not shift properly after a period of time. The pressure control solenoid is used by the PCM to raise the mainline hydraulic pressure during high throttle - this increases the holding force on the clutches and bands and prevents slipping. The pressure control solenoid is controlled by pulses from the PCM and this in turn operates the boost valve insde the valve body.

The problem could be either in the PCM or it could be an electrical problem with the solenoid. As suggested it should be diagnosed by a transmission tech. They can check if the PCM is good by looking at the pulses with an oscilloscope at the connector and they should also be able to test the continuity of the solenoid. If the solenoid is faulty the valve body will need to be removed and the solenoid replaced.
good luck

It is under the dash on the left side of the steering cloumn and is hard to see. You will need a flashlight and a fuse puller to make it easier.

its their somewhere ?? but i dont know what one

The PCM lost its memory. Just drive the car. As long as nothing has been touched under the hood then it will be fine in a few miles give or take.

This is normal. It will relearn

did not receive a reply as of this time

Replace the on-board computer, also know as a PCM (Power Control Module) Click on the links below to read more about it

http://www.2carpros.com/forum/2006-pontiac-vibe-2006-vibe-vt275423.html

http://www.aa1car.com/library/pcm.htm

it might be the fuel presure regulator is pluged
also might be a week fuel pump

Yes they can, only if they can prove to you that the problem was casued by you under UNnormal Circumstances.

2006 Pontiac Vibe Car Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 7440
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 921
Fog/Driving Light Bulb Size: 9006
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 7440
Dome Light Bulb Size: DE3175
Step/Courtesy Light Bulb Size: DE3175

Heres the shifter:
(IMG:http://i50.tinypic.com/29b0wer.jpg)
Push The little plastic cover up:
(IMG:http://i46.tinypic.com/2hzhn3l.jpg)
Put your finger under the plastic cover:
(IMG:http://i48.tinypic.com/2wr2bs4.jpg)
And simply pop it off (IMG:style_emoticons/default/smile.gif) :
(IMG:http://i45.tinypic.com/i5c5ll.jpg)
And there's the bulb, you'll probably need tweezers to get it off:
(IMG:http://i50.tinypic.com/2ng7lfd.jpg)

Good luck

The AWD feature is on all of the time and can not be turned off.

left of steering wheel behind the little storage compartment is one fuse box and then theres one in engine compartment on the left side hope this helps.

Go to your local Auto parts store and have them pull your codes then post on here so we can see what they say. Will help to diagnose the problem. Most of the parts stores will pull your codes for free.

simple]you have a loose electrical connection on the blower.adrian;;;

the liftgate is fitted with two compressed gas support arms.;one or the two are exhausted/need [replaced]these arms have no adjustment you must replace.adrian.;;;;

Look underneath the dashboard, just to the right of the steering column. You will see a black rectangle with the fuse diagram printed on the cover.

Your A/C compressor is suppose to come on with the defroster, this is normal. It is built in that way to help the defroster clear the windshield more quickly. The A/C system dries the air that flows through it so there is no condensation build up on your windows.