Top 20
1992 Mercedes-Benz 190 Questions & Answers
My volvo ran out of oil,now engine shakes uncontrollably
Hi,If the car run out of oil it would have coused alot of damidge to alot of the entunal parts,especialy the crank and the camshaft,this is only too parts out of meney,with out seeing the car I would say that the crank has worped which would couse this.
hope you get it sorted and that the damidge is minimon.
3/17/2014 2:49:20 AM •
1992...
•
83 views • 0 helpful votes
Clutch fan
Sensor malfunction , change it
4/2/2014 8:40:24 PM •
1992...
•
47 views • 0 helpful votes
Changed the Batterys, and there are too many
Battery cables? If so the short black cable with one end bolted to the inner fender near the windshiel goes to the negative or ground battery post...marked on the battery as NEG or/and - .The other battery post clamp is for the positive post on the battery marked + and/or POS.There should be no other cables unless someone has installed a radio amplifier or other power operated items. If so, these will go to the POS + post.
10/27/2013 4:16:50 PM •
1992...
•
82 views • 0 helpful votes
Oil in my collant tank?
hi oil in your coolant tank usually means that your head gasket is blown.
2/6/2013 8:35:20 PM •
1992...
•
74 views • 0 helpful votes
How to adjust idlefor 1992 mercedes benz 190 e 2.6
do you want to adjust the idle up or down? If your car has too high of an idle, you probably have a vacuum leak. buy a can of starting fluid. Start the car and lightly start spraying starter fluid all over the intake. You will hear the engine change RPMs. When it does, that is where you have a leak. If you want to idle your car up, you will need to adjust your throttle plate. Where your throttle hand moves when you rev your engine, it has a little screw that you can adjust to make the throttle arm stop sooner, allowing more airflow into the engine.
1/10/2012 8:05:31 PM •
1992...
•
731 views • 2 helpful votes
Now that i have all of the parts i need to get the
Ok So the air injection is designed to blow cooled fresh air into the catalytic converter to aid in its transference of gases. You may need to get a tube welded on to the "cat" to attatch to the air injection one way valve. An experienced exhaust shop will know right away what to do and shouldn't take but an hour and maybe $50. Great engine on those cars. Let me know if you need anything else.
7/12/2011 12:02:11 AM •
1992...
•
163 views • 1 helpful votes
Fuse no.13 goes
If you put a stronger fuse in, it will burn the spot were the short is, may cause a fire !!
Need to find out what is making it blow the fuse ?
7/15/2011 9:37:47 AM •
1992...
•
102 views • 0 helpful votes
Need instruction on fitting & wiring a towbar
Hi there, the wiring sequence that I have is for the UK, I dont know where you are but I hope this helps
pin 1 Yellow L/H direction Indicator (turn Lamp)
pin 2 Blue Rear Fog Lamps
pin 3 White Earth Return
pin 4 Green R/H direction indicator (turn Lamp)
pin 5 Brown R/H Tail Lamp & No. Plate Lamp
pin 6 Red Stop Lamps
pin 7 Black L/H Tail Lamp & No. Plate lamp
you will have to trace the wires from the wiring loom and light clusters off the car to splice in the towbar wires which is quite easy, the chassis should have location points for the bracket, just make sure that the tow hitch is central and not obscuring the number/license plate..
Good Luck.
4/29/2011 7:05:31 PM •
1992...
•
381 views • 1 helpful votes
Horn does not work
Verify fuse for horn is good.
Check for voltage at horn when button is activated
If voltage is present insure horn is mounted firmly. If there is rust / dirt remove horn and clean both the frame and the horn and remount as a bad ground will prevent it from working also.
If voltage is good at fuse and not present at horn when button activated it could be bad switch or wiring
4/1/2011 12:27:57 AM •
1992...
•
224 views • 0 helpful votes
Both rear whell cilinders need
Your best bet is to shop around local shops like Midas, Tires plus, etc... they have specials and are considerable cheaper than dealer. If you bought parts yourself and did it yourself would be least expensive, but if you've never done wheel cylinder replacement before, this is NOT the car to learn on.
3/16/2011 11:05:41 AM •
1992...
•
33 views • 0 helpful votes
Not finding what you are looking for?