20 Most Recent
2003 GMC Sierra - Page 9 Questions & Answers
I have a 2000 sierra
If the brake pedal goes to the floor and there are no external leaks, then the master cylinder may need to be bled.
My "battery not charging" light is on - I've just
Check all your wiring to make sure there is no corrosion, and definitely check the negative going to the ground. Clean all the connections up and see what you get then. Also you can use a multimeter to see if your battery is actually getting charged or not.
Thanks,
Lee
My windshield wipers will not
The pulse board is located on the wiper motor. It usually has 3-4 screws on it and the female connector for the plug. Remove the screws and it lifts right up. Then remove the plug.
Oil pressure at zero
its possible that the oil gauge go to bad, the oil pressure sending unit may have gone bad, the oil pump may have quit. I suggest you find the oil pressure line coming off engine, put another
oil pressure gauge on it and then just crank the engien to see if you
get any oil pressure whatsoever.
If you don't, then I would check the oil pressure sending unit next
before I tore the oil pan off to examine the oil pump itself. Whatever you do, do not run the engine with zero oil pressure otherwise
you will seize up the engine and that will cost big bucks to repair.
Hope this heslp (remember to rate this answer)
My 2003 sierra blows hot
You need to have a scan tool to see what codes are on the HVAC module.This will help in finding out if it is a air temp actuator not working or a mode door.The actuator for the left side is easy to get to but the one for the passengers side is the hard one.The dash panel has to come off.That is why it is important to get the codes.It could also be wiring or connection.Hope this helps.Good luck.
I have a 2003 gmc
Chances are that the light is coming on in response to a faulty oxygen sensor or something else that will not have a direct effect on performance or fuel economy. It will effect emissions though, so the truck will pollute more than usual and may not pass a state inspection. The only way to be certain is to have the OBD computer read by your mechanic, dealer, or parts store. Many parts stores will "pull the codes" at no charge.
Reset maintenance light
Go to any Autozone and free of charge they will run the code for you, This will tell you "why" the engine light is on. If it's important - fix it or go to shop. If it's something that is minor and doesn't effect the trucks coming and going to next step. Hook up the code reader - again....see if the light comes back on. If it does then ask the Autozone employee if you hold the code reader. There is a "cancel" button to get rid of the code. You can delete the code. The Autozone is not supposed to erase the code. BUT HE CAN LOOK AWAY WHEN YOU DO IT!
Battery not charging sign displayed , voltage
Go to autozone or whatever auto parts store is close to you and have them check your charging system. Most places do this for free and they can determine exactly what part you need to replace.
NO HEAT
Check you thermostat if it is blowing cold air. Also check your coolant level in your radiator.
Not finding what you are looking for?