Top 20
1999 GMC Yukon Questions & Answers
I have a 1999gmc Yukon slt 4wheeldrive and when you put it into gear it cuts off
You have to know what makes the engine stop. It could be many things that cause your problem.
When you put it into gears the engine move so it could be an open circuit or short to ground.
1- The engine load (Mass air flow)
2- Low Fuel pressure
3- Etc........
Start with a scanner and retrieve any engine fault code. If there is, fix it.
There is not much info on your problem if you try something.
Need more info to help you out to solve the problem.
Hope it helps.
The number 1-4 on the vcm of my 1999 yukon the color coded plugs dont have numbers on them but they have colors red blue black wight
There's this website
www.reliable-store.com
They have books on ALL vehicles.
it covers
wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!
Heated seat 99 GMC Yukon wont work ,also antilock brakes engage
The problem is usually in one of the heat pads in the seat - the heating filament is probably broken and the culprit pad has to be replaced (big job). However, you should make sure the fuse is OK (check the owners manual for location).
When the brakes were installed, one of the ABS sensors was either not installed properly, the wiring is disconnected or the sensor has failed - take it back to the shop that did the work.
While driving down the road
problem throttle body or accelerator position sensor
there will be codes but it will need somebody experienced with the right scanner protocol to read them
Not finding what you are looking for?