2004 Dodge SRT-4 - Answered Questions & Fixed issues

At this website www.reliable-store.com I found all complete guide, much better language, complete detail in 800+ pages, and they also have live assistance feature

Not sure if you have one fitted but if it runs while the key is in the start position but dies when you let it back to the ignition position it could be an open circuit ballast resistor. Can you smell unburnt fuel? What voltage is the battery at? Not sure why the warning lights would blink.

Where is a char air sensor saturn vue 2003

the oil sending unit grounds out the dash light bulb as engine speed increases the pressure rises and turn light off normal idle hot oil pressure 30-40 psi. if low then engine bearings are worn.

the SRT4 and SXT parts are not interchangeable, as they are 2 different drivetrains

Are you currently using the original PCM that came with the car or has it ever been changed?

Sounds like it could be a grounding issue. Check for loose wiring that is bolted directly to the frame, body, or firewall components. Is the light on your boost gauge working? Or is your gauge just reading vacuum/boost without the light?

if the light stays on and the engine is quit replace the oil pressure switch

since you said all the fuses are ok, then i will recommend u trace the wire properly and check if any of the wires or sockets are burnt or cut disconnected.. for the SRS light on the cluster, i recommend you run a scan, to know if you are to replace the airbag.


Thanks

Now you own a vehicle that is at most, only 7 years old

If you can not afford an auto parts store manual,which by the way, will be
next to useless,how do you do any preventative vehicle maintainance,or
in your case, possibly break down repairs?

sounds like a door actuator motor that is not working,the dash will have to be removed to repair the problem

Check out all your air hoses and clamps and check the turbo itself to make sure it spins freely. (Engine not running)

can you put it into gear easy, if so it could be your shifting rod

If the check engine light is on, I would take the car to an autoparts store and have them use a scan tool to retrieve any fault codes stored in the computer. Most parts stores will perform the scan for free. Getting the codes will show any engine faults that the computer has identified. Hope this helped and best wishes.

Check your owners manual, this should tell you exactly where it is located.

What code number? It could have a wiring short or open to the PCM or to ground. Cam could be out of time, check the timing belt.

The Crankshaft Position Sensor is located directly next to the starter.

1. On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
2. Remove the Structural Collar
3. Unlock and disconnect the electrical connector to the crankshaft position sensor.
4. Remove the crankshaft position sensor bolt.
5. Remove the sensor

Reverse Order to install except note that:

Use a twisting motion when installing the sensor.

Install and tighten the crankshaft position sensor bolt and tighten to 9 N·m (80 ±15 in. lbs.).

open the drivers door and look near the hinge there is a lil plactic door, You have to pull out the side panel on the dash to get to it.

go find some one that knows how to flash and ecu

how old is and mileage.