20 Most Recent
2003 Chevrolet Tracker - Page 4 Questions & Answers
Front axle
remove wheel, remove upper ball joint, remove large nut in center of rotor, push axle joint out of brake assy, move brake assy out of your way, pull axle out of trans. assemble in reverse order.
Leaking Transfer Case
most Gear boxes with transfer cases have an oil seal between the main gear box and the transfer case so that the oil from the box is not passed through to the transfer case causing it to over fill. If there only a few spots under the car you have time to find exactly where the leak is. May be only an output shaft seal. Check the level of the gear box and transfer case your self It will be level with the filler plug. The oil used is either sae80-90 or oep 80-90. Check manufactures specs on this. If it turns out to be the seal between the two boxes then it will require the unit removal for seal replacement.
V6 tracker po172 and po175
The codes are for the O2 sensors telling the computer the fuel mixture is too rich. One code for each side of the engine.When this happens, the computer tries to turn down the injectors which makes the engine run too lean.Since you have a code for both sides, I doubt the sensors are faulty. You probably have a real problem with the fuel mixture.You would need to check fuel pressure and look for fuel leaks into the cylinders.
Reverse light dont work
No they should only come on when you put in reverse or else everyone would think you were backing up! its your bulb if just one, the fuse if both or the reverse switch indicator... Good Luck
Not finding what you are looking for?