20 Most Recent
2001 Ford Taurus - Page 7 Questions & Answers
Traction control no longer works
There are sensors on every wheel that tell the computer how fast the wheel is spinning. Likely one or more of those sensors is either bad or simply disconnected.
How do i ajust ford transit headlights 2001
There is a conflict with your vehicle and the listing you made for the type of vehicle. But several things to point out. First, if you drive on the opposite side of the road in France versus the United States, the headlight aim would be reversed.
The aim of the headlights can be different in the United States depending on State rules. In general, the curbside light is adjusted higher and the light on the oncoming traffic side is lower. The traffic side is adjusted more towards the center of the vehicle and the curbside is slightly over the curb. You do not want a dark area in the middle of your travel direction.
The vehicle is between 25 and 30 feet from a flat surface The light is adjusted a certain height from the ground. These specs vary and the height of your lights can come into play. Cover the opposite headlight to isolate the beam from the one you are adjusting. A simple towel can cover a lens.
There may be specs in France to cover this.
Why won't it start?
There might be many reasons for a car not to start and just by telling us that it won't start there is no way to give you much help. . Call a towing service and take it to your repar service
Wireless remote and the only key i lost can i change the cyclinder out
you can but if you use the services of a locksmith to do it , he should be able to do and then recover the key cut code so that you still have only the one key for all the locks
you problem is ,if it is a fob key that has a battery in it then a new lock or key will require a reprogram of the immobilizer system to get it to start.
My 2002 Taurus accelerator runs too high. How do I adjust it?
The idle on this vehicle is computer controlled and there is no adjustment available. You may have an issue with the idle air control motor or possibly a vacuum leak allowing unmetered air to enter the engine. Inspect all vacuum hoses for disconnect/cracked hosing. Is check engine light on? If so, have codes scanned to possibly point you in the right direction with any faults that may have been stored in the computer
Trunk wont close
check to see if the latch is stuck in the closed position. if so open the latch with a screw driver then lube assembly and try closing the trunk. if its broken go to a wrecking yard and get a used one.
Not finding what you are looking for?