need to replace the camshaft sensor also in tandem w/crankshaft sensor. trouble codes need to be removed from computer. after repair. both the air & fuel filters need replaced. how's your oil change doin ? try this brandi, see if that takes care of it .
Unfortunately, replacing a sensor only fixes the problem about half the time. The code means the computer is not getting a signal from the sensor, not that the sensor has failed.The problem could be in the wiring, or the part that the sensor gets the signal from.
as long as the starter wasn't removed from the car you should not have to adjust it at all. if it was removed the best rule of thumb is to make sure any shims that were in it when the starter was removed go back in it when you are done. if it wasn't removed just make sure you put it back in there nice and tight