20 Most Recent 2005 Ford F-150 - Page 8 Questions & Answers

are the lock motors bad?the rubber around them dry up and allow water in them.

still in 4 wheel drive ! you have vaccum problems !

usually you can take it to an auto zone and they will use their diagnostic tester, that will tell you the problem

Jack up the truck and see if brakes are locked.. or just try pushing it if it rolls its probably a trans problem not a brake problem. could be the park prawl is broken in the Trans.

p0306 refers to cylinder 6 misfire detected===causes engine mechanical fault--wiring---ignition/fuel system--injector ---ECT/MAF sensor---ECM IF there was a mechanical fault (hydraulic follower ) or valve it would be there most of the time and not just on start up. Possible injector fault but I would be inclined to check out the MAF sensor codes p0351 &2 refer to ignition coil A and ignition coil B primary /secondary--circuit malfunction === causes --wiring--ignition coil--ECM ( all causes for the both) going on this check out the coils and check that the wiring and connections are clean and tight. basically I would be inclined to change out the coils and check /replace the MAF sensor. change the engine --sounds like advice to get some extra money out of you.

sounds like you should change the air flow meter. good luck

Hi if its not clearl marked in one of the fuse boxes it will be in the back of the stereo unit. 4amp? Roger