20 Most Recent 1994 Ford F150 Styleside Supercab - Page 6 Questions & Answers

try replacing the oxygen sensor(s). PLEASE RATE MY ANSWER.

A number of things. Tire with low air pressure, alignment, unbalanced wheel, and possibly pitman arms.

Locate the wiper motor, and disconnect the electrical wires from it by unplugging them. The wiper motor is in the engine compartment against the back firewall near the driver's side. Disconnect the wiper arms from the wiper motor linkage by using the pliers to remove the clip. Locate the wiper motor in the engine compartment on the back firewall and remove it with the proper size wrench. There are three attaching bolts. Remove the wiper motor by twisting it around if you have to. The wiper arm linkage will come out with it. good-day !

3Remove the cowl grill under the windshield wipers using the proper size screwdriver. This is the grill that you see under the wiper arms before the engine compartment hood starts.

Read more: How Do I Remove a Windshield Wiper Motor from a 1994 Ford F-250? ' eHow.com http://www.ehow.com/how_7195498_do-motor-1994-ford-f_250_.html#ixzz1odr1irhn

chances are that you have an E4OD transmission. It a good transmission, however it's electronically controlled (the E, in E4OD). What this means is that many things outside of the transmission itself can cause the transmission to act up. First thing's first... ensure that your fluid level is sufficient. Then, click the link below to read the thread about the E4OD diagnosis process. good luck.http://fullsizebronco.com/forum/showthread.php?t=122096&highlight=shifting

It should be fairly simple ,start at one end ,and work your way to the other. I would remove the plug wire from 1 plug at a time in order to insure that you don't get them mixed up.remove the wire from the first plug,(making sure that there is nothing that will fall into the plug hole,such as dirt,grit ,or any other dabree.)Then remove the plug with a suitable sparkplug socket,(short extention if needed),and a good ratchet.the plugs should turn counter clock wise to come out and clockwise to tighten.There should be a knob,or button on ratchet to change direction of rotation.Be carefull to get the new plug started straight in plug hole!! Make sure they are gapped propperly,and that's about it! I hope this helps!

check your fuses, something is blowing out your bulbs or causing a lack of electrical support, and cant support all your lights working at once...let me know how it goes

try different positions with nozzle not to far in somewhere near the middle

what about it?