20 Most Recent
1982 Ford F 250 - Page 8 Questions & Answers
82 Ford F250
do you mean the callipers or the disk? the callipers you should find on the rear of the calliper two bolts should be 1/2 in or 13mm,these bolts are in between the slider bolts for calliper. if they won't go willingly try heating them up with a propane torch be careful not burn the pads or the hose or sensor if you have one once warm try agin with a socket or wrench if no lu goto any car parts store and get some liquid wrench wait til they cool and sprayon wait til next day and they should come out alot easier ...if its the disk use a big hammer or a small sledge don't hit it on where the pads go oron the edge a firm hit close to the hub will doit .. be careful once you have the calliper off make sure you tie it up with some rope or a bungie so you damge the hose godd luck
2013 Ford F-250 Sony SYNC 2 system. Radio and backup camera problems
Radio Volume and Sound Issues:
The fact that the radio is on but the volume knob doesn't respond and there's no sound from any source suggests a problem with the Digital Signal Processing (DSP) module. This module is responsible for audio processing and distribution.
The C1001:01-68 code points to a fault in the rear camera, while the B1215:00-28 code indicates an issue with the Accessory Protocol Interface Module (APIM).
Since the HVAC and GPS are functioning correctly, it's likely that the APIM itself is not operating as expected.
To address the sound issue, consider replacing the DSP module. Here are the steps:
Remove the subwoofer (it's held in place by three bolts).
Install the new DSP module.
Use FORScan to program the replacement module.
Backup Camera Issue:
The backup camera has also stopped working, displaying a message to contact the dealership.
You might want to try the following common fixes:
Master Reset via Software in SYNC 2: This can sometimes resolve camera issues.
Forced Reset via Disconnecting the Battery: Disconnect the vehicle battery for a few minutes and then reconnect it. This can reset various modules, including the camera.
Replacing the Camera Itself: If the camera remains unresponsive, consider replacing it
Vacuum diagram for 1972 Ford F-250 360 engine
FOR THE WHOLE CAR (USA TRUCK)????????
VACUUM BACK THIS IS FOR SMOG TOO.
AND CALIF CARS AND USA FED CARS NOT THE SAME.
THE SERVICE MANUAL FULL IS ONLY IN PRINTED BOOKS
NOBODY SCANS 1000 PAGES TO PDF FOR FREE EVER
SO BUY THE BOOK USED ON EBAY (PURE LUCK 51 YEAR OLD BOOKS , WOW. HARD.
OR GOOGLE TO THE END OF TIME , & PRAY/
1988 f250 efi will start
he idle speed in this engine is controlled by a part called the ISC, they get full of sludge and cause stalls, please do the following and it should clear up the problem.
To correct this problem get a can of throttle valve cleaner (it is made by CRC) from the local auto parts store, spray it into the air intake of the engine until you have used about half the can, you will need to hold the idle up while you do this, it will try to stall, after this shut the engine down and disconnect the Negative (-) battery cable for 5 minutes. The intake is now clean, if you continue to have the idle speeds problems you may need to seek the help of a professional.
Not finding what you are looking for?