20 Most Recent
2006 Ford Crown Victoria - Page 5 Questions & Answers
Code p 0962
Your truck is in LIMP HOME mode, you have a fault with the EPC electronic pressure control solenoid in the transmission. I suggest you contact a ****** repair shop for this.
2006 Ford Crown Victoria HVAC only blows thru windshield defrost
You have a vacuum leak. Defrost is the default postion(no Vacuum). Start by finding the small black vacuum line near the heater hoses at the fire wall under the hood.Trace it back, it should go to a square black reservoir . Not totally sure exactly where it is located on this model,shop manual doesn't show a very good pic, but it states to remove wiper arm and pivot shaft to remove it. You will see a second line going from here to intake manifold vacuum port. Make sure you don't have a leak there somewhere.
My cooling fan stooped
check your vlcm-variable load control module, located in front of the radiator (has fins, and has a large harness attached to it)-the harness may need to be tightened or the module itself may be bad-before to replace it swap relays for the AC with the ABS to see if it is just a bad relay.
Not finding what you are looking for?