Top 20 1997 Ford F250 SuperCab Questions & Answers

0helpful
1answer

I was pulling a 20' travel trailer with my 1997

Time for a GOOD SIZE trans cooler!
3/1/2018 12:42:03 AM • 1997 Ford F250... • 68 views • 0 helpful votes
0helpful
1answer

I have a 97 f250 with the 5.8L in it. I went out

run the fault codes indicates that the ambient temp sensor or BARO sensor are not working and reporting to the ECM so that the correct air/fuel mixture can be set for starting
11/19/2017 2:24:03 AM • 1997 Ford F250... • 491 views • 0 helpful votes
0helpful
1answer

2001 f-150 5.4 auto, overdrive light flashing

There will be a code in memory which will indicate the problem. From you saying it flashes at cruise it is most likely your torque converter is not locking up as it should.
11/16/2017 3:09:03 PM • 1997 Ford F250... • 264 views • 0 helpful votes
0helpful
2answers

I have a 97 F250 with a 95 International pre

air in the pump and injector lines bleed the air out of the pump and loosen the injector line nuts to bleed the injectors check for problem furl line , filter seals , pick up line in the tank, and tank not venting properly
11/24/2017 4:00:19 AM • 1997 Ford F250... • 77 views • 0 helpful votes
0helpful
1answer

97 f-250 diesel blinkers and ABS light

Hello, If your low beams work it's not the multi-function switch located on your steering column (two bolts and a plug). If you unplug the abs sensor on the rear differential and the ABS stays on and your blinkers work and you don't blow fuses could be the sensor. However, if this is not it you may have a ground problem (micro-friction). Usually these two systems are not connected and these may be completely different issues. Possible Scenario: aftermarket stereo installed incorrectly. Scenario Two: both of these sytems have bare wires and touch every so often causing your grounding problem. (There is a fuse-vibration testing technique that can be used to find the bare-wire(s)) Try to fix the blinker problem first you may find the ABS problem along the way (common wires of Blinker/ABS bundled together. Trace and inspect. Hope this helps--
6/6/2017 3:00:08 AM • 1997 Ford F250... • 217 views • 0 helpful votes
0helpful
1answer

How do i fix oil going into air intake manifold ?

check and make sure push rod didnt damage head,rocker , valve or lifter [which i would replace]if all looks good clean repair and replace
7/10/2016 10:55:34 PM • 1997 Ford F250... • 93 views • 0 helpful votes
0helpful
1answer

The light on the overdrive is flashing always and don't change the gears on the overdrive,

there is a code in the TCM that needs to be checked out.
8/27/2015 5:43:21 PM • 1997 Ford F250... • 871 views • 0 helpful votes
1helpful
1answer

I have a Ford F250 with a 7.3 Diesel engine. Is it a good idea to add transmission fluid to the diesel fuel? A friend suggested this to me.

I drove truck for 30 years, and I used the trans fluid in diesel fuel to help keep injectors clean! Just be sure not to use too much! I would only use a 1/4 of a quart per tank full.
4/4/2015 12:26:24 PM • 1997 Ford F250... • 232 views • 1 helpful votes
0helpful
1answer

MY FORD F250 97 5,8 L TRUCK OVERHEATED AND NOW WONT START

You just gotta face it: your engine is munched. Sorry. Nothing but nothing will totally ruin an engine faster, or more thoroughly, than overheating. And the damage that is done it not the kind that can usually be repaired. Every component of the engine is likely ruined, every single internal part. If you would have turned the engine IMMEDIATELY off, and coasted to the side of the road, you might not be in this position. But since you ran it until it started pounding ("pinging" you called it), you can rest assured that it will likely never run again. Sorry!
2/28/2015 9:01:49 AM • 1997 Ford F250... • 140 views • 0 helpful votes
0helpful
2answers

How do i change a/c and power steering belt

Usually need a 1/2" drive placed into tensioner pulley and ease it back till you can remove the belt off it. Then the belt will slide out so you don't have to remove anything. Follow the reverse order to put back on and follow the diagram under hood usually in plain view if you forget. It can be somewhat a puzzle depending on how many pulleys it needs to wrap around... You will not need to remove anything if you do it right. Also buy the 3 year plus one since the other needs to be replaced yearly...
4/1/2015 4:39:32 PM • 1997 Ford F250... • 51 views • 0 helpful votes
1helpful
2answers

Side windows

Sounds like a failing or dirty switch. I had a car that did that and it turned out that the wiring harness connection to the switch housing had worked loose making a partial connection.
3/4/2015 11:19:05 AM • 1997 Ford F250... • 43 views • 1 helpful votes
0helpful
1answer

Side windows sometimes work sometimes don't is there a fuse or relay

More than likely it will be your switch for the power windows
3/4/2015 11:12:41 AM • 1997 Ford F250... • 41 views • 0 helpful votes
0helpful
1answer

When i recently drove my 1997 f250 on hyway , i had big bang from truck ..i thought it was my tire . Lost 4th gear .. .i stopped it and looked under hood and truck ..i didnt see any dripping. ... I

Manual or automatic transmission? Diesel or Gasoline? Either way you have internal damage to the transmission. It will either need rebuilding or replacing. A lot of times, repairing is less expensive than buying a new vehicle.
11/12/2014 12:01:26 PM • 1997 Ford F250... • 73 views • 0 helpful votes
0helpful
2answers

My 97 ford f-250 is running very rough

I would chweck igniton first...miles? and previous service?
9/15/2014 7:02:30 AM • 1997 Ford F250... • 266 views • 0 helpful votes
0helpful
1answer

How to remove headlight assembly for ford f250 super duty?

There should be three screws holding it in from behind. They will be three long post looking type of stand offs. Remove those and the whole assemble will come out with a pop.
7/26/2014 8:30:52 PM • 1997 Ford F250... • 644 views • 0 helpful votes
0helpful
1answer

Doesn't turn over...something clicking in hood when key is turned

U probably hear the starter relay...starter seems to be bad..make sure wires are thought and damage free...can "hotwire" starter to check if its working properly
9/3/2014 11:43:49 PM • 1997 Ford F250... • 129 views • 0 helpful votes
0helpful
1answer

Cylinder numbering on 5.4 v8?

on passenger side from front to back cyl`s #1,2,3,4 on drivers side front to rear cyl`s 5,6,7,8.
9/6/2014 5:45:14 PM • 1997 Ford F250... • 45 views • 0 helpful votes
0helpful
1answer

Where is the shift interlock actuator located on my 1997 ford f250

2wd or 4wd? shifting what, A/T M/T or 4wd.? try to say what you have first then post a question specific to a part. are you inside the tranny or just inside,car.??? her are lots of interlocks, my wild guess, is a/T park lock circuits and parts. right? inside car?
5/4/2014 12:38:39 PM • 1997 Ford F250... • 307 views • 0 helpful votes
Not finding what you are looking for?
1997 Ford F250 SuperCab Logo

580 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

F-250 Ford

  • F-250 Ford

Most Popular Question

ford f250 7 3 diesel engine good idea

  • Cars & Trucks
Loading...