20 Most Recent
1997 Ford Crown Victoria - Page 2 Questions & Answers
4.6 gas engine plug Gap ?
Hi Dean:
Odds are really good that your local parts store (ie Canadian tire) will have a book with the make, model, engine size that will tell you the appropriate plug AND the correct gap. Even if you just want to reset your old plugs, the info would be available, AND FREE!!!
Horn does not work 97
FIRST I WOULD CHECK THE HORN FUSE OR RELAY ...CHECK YOUR OWNERS MANUEL TO SEE FOR LOCATION PROBABLY UNDER HOOD IN A RELAY STATION BOX.IF THOSE ARE GOOD..THEN POSSIBLE BAD HORN ITSELF OR BAD CONTACT BEHIND THE DRIVER AIRBAG,STEERING WHEEL.
Why is oil coming out of 1997 crown Victoria tail pipe
Can be several things. None are good. Oil seals on valve stems are a potential problem. A bad head gasket can leak if the design has oil passages in the heads. The last reason would be oil rings on the pistons.
There are some ways to test to determine which of these 3 problems it is. The tests can be done by a Mechanic and involve pressurizing the inside of the engine in different ways to see which part is at fault.
About the only positive news is that there is a difference between removing 1 head and removing both heads. You only need to fix the side of the engine that is bad. The good side can stay sealed.
There are products which plug oil leaks internally if the gasket is the problem and you may not need to tear apart the engine if the additive works.
How do I remove 1997 ford crown Vic headlight assembly on right passanger
remove the clips that hold the radiator support cover and remove the cover look down at the top of the light assembly and you will see two or three clips that hold it in just spread the clips or use a snap ring plier to get them out and remove all three and remove the headlight assembly the bulbs are held in by twist lock connectors push in and turn DO NOT TOUCH THE NEW HEAD LIGHT WITH YOUR HANDS THE OIL FROM YOUR SKIN FRIES ON THE GLASS AND BLOWS OUT THE BULB WASH YOUR HANDS FIRST THEN DRY THEM HOLD THE BULB IN PAPER TOWELS below are photos of your stuff the clips have little legs on them that fit into the black plastic adjusters shown in the center of the headlight I couldn't find a photo of the other side showing the legs but you'll see them when you look down at the back of the light the snap ring pliers fit into the holes on the tabs you see and then spread the clips for removal
No turn signals or emergency blinkers
Sounds like a multifunction switch, work the emergency flasher button up and down a few times, then attempt to work the turn signals if the signals work then you will need a multifunction switch.
My 97 ford crown vic. engine will shut off when the ac is turned on what's happening?
With the engine off, key off, try to turn the front part of the AC compressor (not the pulley and belt, but the front part of the clutch). If it cannot be turned, the compressor is seized up and needs to be replaced. If it turns freely (there should be a little resistance, but turn easily by hand), the problem may be electrical- A short in the wiring, or defective engine ECU.
Why does 20 fuse plugged into 16 fuse hole spark and blow.
It is doing its job(blowing when there is more current flowing than there should be). What circuit is that fuse in? Whatever the load is(light switch, radio, etc) has an internal short or the wiring between the fuse and the load is shorted to ground. Also never replace the fuse with one that has a higher current rating. That's when you start melting wires and other things that you don't want to melt. Good luck!
97 crown victoria, headlights, blinkers, brake
May be your multi function switch( directional switch),possibly a bad fuse,a LCM (lighting control module,a black box by the gas pedal,or maybe a plug pulled out of the module for some reason.
Not finding what you are looking for?