1992 Dodge Ramcharger - Answered Questions & Fixed issues
My1992 dodge van stalls when i put it into gear sometimes.
Please check your motor mounts.
A broken, or even a worn motor mount or two can negatively pull on your linkages so that your van will do this.
Understand that if the motor and/or transmission moves loosely, other things can be affected, such as shifting gears and wiring.
God bless your efforts.
4/17/2017 8:30:34 PM •
1992 Dodge...
•
Answered
on Apr 17, 2017
•
258 views
Change ignition switch
If it is on the steering column you will need to remove the steering wheel and the plate behind it. Then remove the screw are it may be a slide pin but ether way remove it , that is what hold the switch in the steering column . Replace in reverse order. By the way if you dont have a steering wheel puller go to auto zone they will rent you one believe me it will make taking the steering wheel off a lot easier. Good luck.
2/2/2015 10:26:52 PM •
1992 Dodge...
•
Answered
on Feb 02, 2015
•
138 views
Flooding out bad
There is only one way for gas to get into your oil pan and that is past the piston rings, if they are worn bad it also effects vaccuum pressure and throws off fuel regulator and all sorts of other ****.
Do a compression test to find out,
8/26/2014 4:35:31 AM •
1992 Dodge...
•
Answered
on Aug 26, 2014
•
168 views
1991 dodge ram 360 w/throttle body problem
Float is stuck in carburetor needle and seat probably stuck open remove the top of carb Check for dirt in the float bowl spray clean with carb cleaner try turning over the motor and see if fuel stops when bowl is 2/3 rds full if not clean again and make sure you have a in-line fuel filter installed also.
8/26/2014 4:31:55 AM •
1992 Dodge...
•
Answered
on Aug 26, 2014
•
589 views
Throttle body doesnt take in air when accelarating
The engine is a vacuum pump & a compressorSo it is taking in all the air it needsDon't know what was accomplished changing athrottle bodyDon't really know if you had a thing tested & how or whyWhat are the driveability symptoms,who is working on them?
12/13/2012 4:49:54 PM •
1992 Dodge...
•
Answered
on Dec 13, 2012
•
86 views
Will a flywheel make a
I have never heard of that happening before. More than likely the timing chain is worn, or the cam sensor is weak; however, make sure that the plugs are gapped properly and that all sensors are performing correctly since they are a part of the loop that causes the computer to set the timing off of.
11/23/2010 12:46:47 AM •
1992 Dodge...
•
Answered
on Nov 23, 2010
•
80 views
1992 dodge caravan has no power to the coil
It is possible that the crank sensor is bad. I would suspect PCM or wiring also. Make sure you have continuity from the connector to the PCM. If you do, you have a bad PCM, if not, you have found which wire is bad.
9/2/2009 10:11:30 PM •
1992 Dodge...
•
Answered
on Sep 02, 2009
•
194 views
So my timeing is off on the 92 ramcharger. its
the hood should have the info stickers that tell you how to adjust base timing. poof i just looked it up and it takes a couple of special tools. ( one to hook up a tool to the iac harness connector. the other is a min air flow done also with a special orifice. Sorry :(
8/3/2009 5:54:29 AM •
1992 Dodge...
•
Answered
on Aug 03, 2009
•
107 views
It will start some times and not other and shut when running
Check ASD Relay (Automatic Shut Down) Kills fuel and spark. Computer could be telling it to shut down, but usually Relay is bad. Key Switch could also be bad, get a good manual and a VOM (Volts, Ohms, Milliamps) meter, and make sure you have juice both coming in and going out, in the respective key positions. Jiggle wiring while testing, to check for loose connections
8/1/2009 2:21:52 AM •
1992 Dodge...
•
Answered
on Aug 01, 2009
•
314 views
1992 Dodge 250 van, 318, Automatic - Dies when coming to a stop
I cannot see how adding a fuel additive would help to be honest. I would be looking for a split or leaking vacuum line, I have even seen a leaking evap canister before that caused a similar problem.
Does the engine pull clean and strong when it is warm or at cruising speeds? Does it feel like its running lean or misfiring?
4/9/2009 5:47:27 PM •
1992 Dodge...
•
Answered
on Apr 09, 2009
•
700 views
Not finding what you are looking for?