1994 Dodge Ram - Answered Questions & Fixed issues

you wont fix it take it to a auto electric . unless you got a lot of time . thers a short in harness gonna have to trace each wire ..oh boy oh boy

Take a torch to it.

I would replace the catalytic converter.

check the wires that you repaired problem may be further back or completely damaged

Possibly a bad alternator ! Go to auto zone and they will run a check on it for free . But check for corrosion on the negative terminal first !

I don't know what the vehicle manufacturer's recommendation is but I do know different spark plug manufacturers gap specifications vary slightly from each other. I advise you to check in the applicable spark plug application catalogue. Most of them are available online.

DODGE RAM SERVICE REPAIR MANUAL 1989 1990 1991 1992 1993 1994 1995 1996... for the easy solution download the pdf file

Replace it, tapping the tank only gets you 1 time if the pump is worn.

Try a tune up except Filter`s .

A full Tune up .

Goggle it

The blower fan fuse in a 30amp, light green in color. When the fan would not work, was there an abs light on or power windows or radio inop also?

It is hard to get to - the sensor is at the back of the engine mounted through the transmission bell housing. The connector should be within 6 to 8 inches from the sensor. The sensor reads a sensor ring on the flywheel/flexplate.

OEM Recycled New Aftermarket Reman Parts Cars Trucks and HD LKQ, IF THEY DON'T HAVE YOUR OUT OF LUCK.

INTERMITTENT PROBLEMS CAN BE VERY HARD TO FIND. FIRST CHECK FOR STORED CODES. INSIDE THE DIST THERE IS A HALL EFFECT SWITCH THAT TELLS IT WHEN TO FIRE. THEY FAIL FAIRLY OFTEN

Check the ignition timing

bad dimmer switch.

ignition switch is faulty.worn out.replace.

On firewall, if it has one. Not sure that a 1994 modle uses that type of ignition as the older ones did.

Yes. Often times recycled electronic modules are tested for functionality, not long term performance. Long term testing requires running the device under load and temperature conditions for 24 or more hours, to determine if there are any thermal issues. Computer manufacturers of mother boards (for PC's) are notorious for this practise.