1988 Dodge Ram 50 - Answered Questions & Fixed issues
1988 dodge ram 318 engine
Code 12--Battery Disconnect---Direct Battery input to PCM disconnected within last 50 ignition key-on cycles.
Normal if battery has been disconnected, otherwise check battery power and
ground connections.
Code 37--Torque converter clutch
solenoid CKT or
Trans temp sensor
too high or low---Open or short in CKT wiring or connectors. Voltage out of range at transmission
temperature sensor input.
Code 55--End of message code. A DTC 55 is used to end all DTC messages.
When is the last time you had a tune-up?
I
would start by replacing the cap, rotor, plugs and wires. Also, check all hoses for vacuum leaks.
I hope this helps.
Where is the Fuel Filter located on 1988 Dodge Ram 50
1988 Dodge Ram 50 fuel filter is located adjacent to fuel tank. More specifically, the fuel filter is directly above frame rail at front end of fuel tank. The fuel filter and retaining clip can be seen between the two bed mounts on the driver side.
I can not get my truck threw inspection for a high idle
you are going to have to take it to a shop so they can calibrate the idle, there's two screws you have to mess with and it's not worthy to try to do it yourself, it'd be very frustrating, sorry. It happened to me and it took me months to finally give up, I paid only $60.
1988 dodge ram wiring diagram
If you don't want to test or don't know how,then you either have to learn or pay someoneYou can get a wiring diagram at any local repair shopwith a data base,provided the data goes back to 1988You have to test peroid if something isn't working, you have no choice,you can not replace parts to resolve thingsWhy would you say wires need replacing? Repaired in placesmaybe
88 ram 50 strugles at high rpm
theres a modole in under the rotor button the distribiter check that and yes fuel pump and even the filter can cause it//start with the filter its cheaper
Not finding what you are looking for?