20 Most Recent 1995 Dodge Ram 3500 Questions & Answers


tubo units get compressor drive power from the exhaust pressure acting on the turbine wheel, not after the turbine wheel so exhaust pipe /flange leaks are non effective
what you problem indicates is a holes in the intake system after the compressor wheel from bad intercooler pipes /hoses loose and or holes in the intercooler
another place of failure is a faulty boost dump valve that is not allowing pressure to build up at all
make sure that the air filter is new as any restriction is a problem
of course you could always take the car to an accredited turbo repair shop and just talk about it and get information as to the possible problems

1995 Dodge Ram... | Answered on Sep 13, 2017


wiring for what/ the engine? whole car? or????

1995 Dodge Ram... | Answered on Dec 03, 2015


i would replace the starter and silinoid sort of hard to say with out hearing it or seeing it

1995 Dodge Ram... | Answered on Nov 14, 2015


Numerous Conditions May Cause Engine to Crank But Not ...

repairpal.com > Problems > Dodge > Ram 2500
2006 Dodge Ram Laramie 2500, 5.9i liter Cummins ... I know in the old days the dodges had a way about starting up an engine and that would be where.

White smoke, rough idle at startup - Dodge Cummins Diesel Forum

www.cumminsforum.com > ... > 3rd Gen. Powertrain
Jun 5, 2010 - 9 posts - ‎7 authors I have an 06 Dodge 5.9L that has a light white smoke and rough idle when first ... 2006Ram 2500 QCSB 4x4, 3" Carli coils w/ 1" Daystar spacer, ... Still ran good tho, dispite the exact conditions you describe on Cold Start up.

1995 Dodge Ram... | Answered on Oct 22, 2015


Sorry you are having trouble.
This is a major under job. You did not specify the engine size.
A manual will be a great help to you but I will tell you the basics
Remove the exhaust from the head (difficult)
Remove the intake manifold(difficult)
Remove everything else connected to the head(difficult)
Remove head(easy)
Install new gasket (easy)
Put it all back together
I hope this helps

1995 Dodge Ram... | Answered on Apr 17, 2015


you need a new heater core

1995 Dodge Ram... | Answered on Feb 07, 2015


First off, how old is the battery? It is possible it might be stratified and its just no longer holding a charge well. I've had batteries that are 2 or 3 years old and then they just go dead if I don't start them up every day or so. (Some batteries are just made better than others) If the battery is brand new, then check for some possible wiring shorts. Try looking at the engine running in the dark and try moving around the wiring harness to see if by chance you see any sparks or arcs of electricity. Other than that, you might have to have a qualified auto electric mechanic to check it out for any abnormal power drains.

1995 Dodge Ram... | Answered on Apr 02, 2014


it sounds like a fuel pump .remove the fuel inspection cap on the fuel rail at the top of the engine and make a pump presser check,must be around 45-65 psi, anything lower means a defected pump.another way
of checking a pump is banging on the fuel tank while having some body cranking the eng. if the eng fires up it means it is a pump.

1995 Dodge Ram... | Answered on Jan 18, 2014


Mine was located on the driver side rail, on the drivers side of the transmission near the middle of the drivers seat. It was BOLTED to the rail and was very rusted. I think it took two hours for penetrating oil to loosen it up

hope this helps

Jim

1995 Dodge Ram... | Answered on Nov 27, 2012


Do a OBD1 fault code test and see if a speed sensor code shows up, if this sensor is defective it will cause the truck to drop out oif OD. The VSS sensor is located on the drivers side of the transmission case. Use the Check engine light flash out to read the code.

1995 Dodge Ram... | Answered on Apr 13, 2012


it sounds like the starter solenoid contacts are not separating to stop the starter from turning.the run on is due to the starter not stopping causing the motor to continue to spin.replace the starter unit as it will have damage due to being engaged with the motor running,also have the flywheel inspected to make sure the teeth are not damaged on it.

1995 Dodge Ram... | Answered on Apr 12, 2011


Someone has put the wrong lift pump on ( too high of pressure )

1995 Dodge Ram... | Answered on Feb 27, 2011

Not finding what you are looking for?
Cars & Trucks Logo

Popular Tags

93 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ram 3500 Dodge

  • Ram 3500 Dodge

Most Popular Question

99 dodge ram 3500 diesel

  • Cars & Trucks
Loading...