Top 20
1987 Dodge Ram Wagon B250 Questions & Answers
Tail lights
Most likely a bad ground. Causing power feedback to get enough ground to light at all . Find the ground screw. Remove it and clean the area. Apply a little Die Electric to the metal and the wire end, being sure the wire end is clean as well.
I have a dodge ram 250 van 1987, front brakes are
Most often that condition is caused by the rubber hoses that connect the caliper to the "hard" brake lines at the chassis. The hose may appear good but internally it collapses and prevents pressure from releasing. After correcting the problem be sure to replace the front pads as likely they are burned. If the pedal pulsates replace the front rotors as well, or, if they are still in relatively good shape, have them re-surfaced.
Right turn signal rear of
Follow wirin harness from tail light forward look for an open circuit,broken wire,spice or conector
No dash lights, no power
It goes straight to the mains fuse box on the firewall inside the engine bay and from there to the battery.
But if you smelled burned then it has surely fried other wires - you will gonna have to cut the loom open, find the shorted wire, inspect all the wires around it and replace the shot ones.
My revirse lights do not work
Really dont need to know color of wire for this system is simple. On the switch (left rear corner on transmission) there are three wires. one wire is power, one allows it to start in park or neutral and the other is for the reverse lights. If I remember correctly the two outer terminals operate the reverse lights. Find the power lead and jump to each of the other two to determine which is for the reverse lights. Likely you will find that the switch is bad and there is no wiring problem. Make sure that reverse lights have good grounds as well.
1987 Dodge B150 "Check EGR" light?
hello, if you have a vacuum pull off choke, you can try replacing your thermal vacuum valve on the intake manifold, it fits with the slow rpm..s at cold start!! Good luck, cheap repair if it works for ya. marty
Dodge Ram B250 1994 - has a Starting Problem
if you van has a security system in it, it could be causing this problem. they usually disable the starter circuit. Paul has listed good places to start. but if they don't fix it do this: when your trying to start but its not working have some one check voltage at the starter. there are 3 points to check 1: where battery cable connects 2: where starter connects to solenoid 3: small wire that operates solenoid. if there is voltage at all three point replace starter it has a shorted / open spot on armature. voltage at 1 and 3 but not 2 replace solenoid. voltage at 1 but not at 3 and you have already checked the items Paul identified check wiring between neutral safety switch and solenoid.
Not finding what you are looking for?