2005 Dodge SRT-4 - Answered Questions & Fixed issues

0helpful
1answer

Why does power steering fluid leaks out on left side ? makes whining noise i fill it up with in an hr its gone whats the problem?

You obviously have a leak. It should be very easy to find, first, crank engine & refill power steering reservoir to proper level. Then have someone turn the steering wheel slowly while you look around the pump, hoses & rack & pinion unit. Wherever the leak is you will see fluid leaking when the steering wheel is being turned. You can also turn the wheel all the way to either the left or right until the wheel binds up, (which puts the system to full pressure and at the same time keep pressure applied to the wheel) and you will definitely find the leak. It's probably going to be 1 of your pressure hoses. Be careful driving it until you get the leak fixed as you can burn your pump up by running it without/low on fluid. Hope this helps.
6/16/2014 4:51:10 AM • 2005 Dodge SRT-4 • Answered on Jun 16, 2014 • 198 views
0helpful
1answer

Where is the power steering preassure line in a a 2003 Jeep Liberty Sport

It is typically the smaller hose coming off the side of the power steering pump, and going straight to the steering rack. The other line (low pressure) is typically fatter and come back from a radiator at the front of the car.
4/24/2014 5:01:38 PM • 2005 Dodge SRT-4 • Answered on Apr 24, 2014 • 139 views
0helpful
1answer

How to remove srt4 anti theft removal

reprogram security or cumputer
12/19/2013 4:05:42 PM • 2005 Dodge SRT-4 • Answered on Dec 19, 2013 • 961 views
0helpful
2answers

The brake pedal pedal on my car is hard as a rock

booster unit has failed or not getting vacuum from engine. Check vacuum line from intake to booster unit. If vacuum is good, diaphram may have failed inside the booster.
1/26/2013 4:57:11 AM • 2005 Dodge SRT-4 • Answered on Jan 26, 2013 • 277 views
0helpful
2answers

Oil lights stays on

If the engine is not making any noise then it is likely not a real oil pressure problem. Just to make sure have the pressure checked by a shop with a mechanical test gauge and if found to be inspect replace the sending unit and that should in most cases cure the problem. I assume this is a pressure indicator.
9/18/2012 9:33:14 PM • 2005 Dodge SRT-4 • Answered on Sep 18, 2012 • 407 views
0helpful
1answer

What's P-0441 code on srt-4.?

The fault code means" Evaporative Emisson System Incorrect Purge Flow"------------elm327 bluetooth scanner
9/5/2012 2:42:47 AM • 2005 Dodge SRT-4 • Answered on Sep 05, 2012 • 237 views
0helpful
1answer

I get a rumble feeling when i hit the brakes

Probably warped rotors due to heat or poor quality rotors. Resurface or replace rotors and pads ASAP. Brakes properly done will save your life, not to mention keep your sanity
8/31/2012 4:21:45 PM • 2005 Dodge SRT-4 • Answered on Aug 31, 2012 • 120 views
0helpful
2answers

My car just died on my 2004 dodge srt-4 and when

There are leaky capacitors insider your computer ECU) /// inside passenger side left kick panel.

This a well know capacitors issue with 3000GT and SRT-4.


The capacitors part is under $15. Labor time is under 1 hours.

There are ECU swape shop but they will charge you top dollar.


Ask a friend with GOOD soldering skill to do this job.

Good luck.
5/12/2011 4:30:36 AM • 2005 Dodge SRT-4 • Answered on May 12, 2011 • 491 views
0helpful
1answer

Hey i have a 2005

bring it to the shop that did the clutch
5/4/2011 11:52:11 PM • 2005 Dodge SRT-4 • Answered on May 04, 2011 • 375 views
0helpful
1answer

My power steering fluid is

The most common cause is a leak in the power steering line. With someone sitting in the car,(and the car running) watch the power steering line and ask them to turn the wheel in both directions. A leak in the power steering line will spurt fluid during this exercise whereas a leak in the power steering unit itself would tend to ooze fluid due to less pressure.
4/27/2011 1:35:19 PM • 2005 Dodge SRT-4 • Answered on Apr 27, 2011 • 1,664 views
0helpful
1answer

My 05 dodge neon srt 4 is really stuck in 3rd gear

serious transmission problem--check with specialist--or remove tranny & disassemble--& repair.
2/27/2011 4:18:31 AM • 2005 Dodge SRT-4 • Answered on Feb 27, 2011 • 599 views
0helpful
2answers

The transmission gets stuck in

Could be Solenoid failed, that's why wont shift back to 1
2/11/2011 1:45:05 AM • 2005 Dodge SRT-4 • Answered on Feb 11, 2011 • 264 views
0helpful
1answer

I jhust bought a 2005 srt4 47k miles on the way

The oil light means that the oil pressure is low which may mean the oil filter is plugged up or the oil pump is wearing out and not generating enough oil pressure.

The check engine light indicates there is something wrong or out of specs. as far as a sensor on the engine, which should be checked.

An OBD-II Scanner can be used to analyze what is wrong with the engine. Try autozone or advance auto parts since they will scan it for free.

Good luck on the repairs.
11/5/2010 5:43:59 AM • 2005 Dodge SRT-4 • Answered on Nov 05, 2010 • 192 views
0helpful
1answer

Wher is the IAT?

the iat sensor is located in the fresh air duct connected to the air filter in front of the fuse/relay control panel. to remove the iat sensor, renive the air filter cover and using a pair of wire cutters remove the small steel band holding the sensor in place. then by pulling on sensor it will come out. when replaceing sensor be sure to install new metal ring on new sensor to secure it in place.
4/29/2010 10:22:22 AM • 2005 Dodge SRT-4 • Answered on Apr 29, 2010 • 693 views
0helpful
1answer

Where is the fuel filter location

Fuel tank Bossman....


45f6866.gif

It's part of the fuel pump module....



ea3a336.gif
11/26/2010 7:43:47 AM • 2005 Dodge SRT-4 • Answered on Nov 26, 2010 • 892 views
0helpful
1answer

Gears r sticking and happen in 3rd and

Sounds like the sycromesh in the gearbox.
is it manual or auto?
1/20/2010 8:43:03 PM • 2005 Dodge SRT-4 • Answered on Jan 20, 2010 • 80 views
0helpful
1answer

Can u tell me where exactly the fuel filter is

inside the tank
12/17/2009 5:34:46 AM • 2005 Dodge SRT-4 • Answered on Dec 17, 2009 • 297 views
0helpful
2answers

Coolant is blowing out of the radiator cap after

blown headgasket
10/18/2009 3:41:33 PM • 2005 Dodge SRT-4 • Answered on Oct 18, 2009 • 183 views
0helpful
1answer

Everytime i go to give it gas or a little more

the oxygen sensor might be stopped up if the check engine light comes on go to auto zone and they might be able to dignose it
10/18/2009 3:22:00 AM • 2005 Dodge SRT-4 • Answered on Oct 18, 2009 • 90 views
0helpful
2answers

How do i know if timing belt was istalled right?

Hmmmm. I'd have your mechanic check the timing marks on the crank and cam(s) The problem may lie in a simple loose wire/sensor connection, I'd go thru all of these in insure they're snug. If the engine ran well prior to the belt replace and now having issues I'd get it back to the mechanic and have him correct. And for my 2-cents at no extra charge to you.
I hope this may have helped,
Tom
10/16/2009 1:18:21 AM • 2005 Dodge SRT-4 • Answered on Oct 16, 2009 • 199 views
Not finding what you are looking for?
Cars & Trucks Logo

48 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...