leaking fuel out of the drain line,
the yellow valve that you turn to drain fuel from the fuel filter, it leaks out of there when the truck is running
Replace the drain valve. They leak all the time.
Posted on Oct 16, 2008
The truck starts up and runs fine. Then usually after a mile or so the engine feels like it is missing or cutting out. Sputtering usually inreases when going up a slight hill. Definitely not the transmission, it will sputter in park. Truck has had new plugs and fuel filter.
the catalytic converter could be startin to plug up. check the air filter and that you have all the plug wires on the right plugs
Posted on Nov 07, 2008
Im looking for a diagram for the fuse box of a 1999 Ford F250 Flex fuel Gas/Propane. Its the inside fuses. I need the amp and when there are located to i can change some.
ok go to this link they have every fuse panel diagram in your truck
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801e56ea
they also have the wiring diagrams for most things if you need them too you can go to
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801e56fa
Posted on Dec 26, 2008
where is this sensor located on the vehicle?
also where is the exhaust pressure sensor located?
The camshaft sensor is located right above the crankshaft pulley on the passengers side of the front cover of the engine. It will be a 3 pin sensor either gray or black in color. There is a pointer that is attached to the sensor and it is either gold or silver in color. There is also a recall out on this camshaft sensor. If the color of the sensor is black then it should qualify for the recall. If you get in touch with a Ford dealer they should be able to help you with your recall if the sensor is black since it is a safety recall. As far as your exhaust pressure sensor it is located on the front of the engine right by the heater core hose a little to the passengers side of the center of the front of the engine. there will be a tube attached to the bottom of the sensor that goes from it to the front of the exhaust manifold on the very front of the passengers side exhaust manifold.
Posted on Apr 11, 2009
Just bought this truck and the a/c only blows through defrost. I found
several vacuum lines broken and need a schematic of some kind of
diagram . Purchased a chilton manual . worthless! any suggestions
on the fix and is there any vehicle specific manuals with lots of pictures.
Try ebaymotors they have repair manuals on cd that are inexpensive and have electrical schematics as well as vacuum diagrams. $15.00 - $20.00
Posted on Aug 06, 2009
I have a ford f 250 with dtc code p0606, Internal Ctrl Mod Kam Error, what is wrong and how do I correct or fix
There is no P0606? P0602, P0603 or P0605. P0603 KAM interrupt can be a blown fuse or low battery, P0605 can be aftermarket chip / programing or PCM failure (diesels do have a reprogram for false P0605). P0602 is usually a PCM failure.
Posted on Oct 24, 2009
PCM protection diode and PCM relay I have a diesel 1999 f 250, is this under the hood in with the other fuses. or by its self. I have a p0603 Inernal crtl mod cam error, and some one said to look at the above fuse
Fuse #2 in the fuse box behind the driver's knee panel is the 5amp "KAM" fuse. The others,in under the hood fuse box would not be a concern as without them being good the engine will not start and no code read would be possible.
Posted on Oct 25, 2009
How to replace the speed sensor on a 1999 ford f-250 super duty. I can't even locate it on the vehicle.
the speed sensor might be located on the rear differential or it might be located in or on the transmission.
Posted on Jun 30, 2010
firing diagram for 1999 ford f250 5.4L
okay, this should help you:
Firing Orders; (4.6L - 5.4L)
Firewall
(Passenger Side) 4 * 8 (Drivers Side)
(Passenger Side) 3 * 7 (Drivers Side)
(Passenger Side) 2 * 6 (Drivers Side)
(Passenger Side) 1 * 5 (Drivers Side)
Radiator
-------------------------------------------------------------------
Ford 4.6L Engine
Firing Order: 1-3-7-2-6-5-4-8
Distributorless ignition system
Ford 5.4L Engine
Firing Order: 1-3-7-2-6-5-4-8
Distributorless ignition system
(One coil on each cylinder)
Posted on Nov 09, 2010
I have a 1999 F250 Super Duty. I just did a bunch or work to the truck. I put the scanner to it and I got C1226 that came up but description was unavailable. I did some looking and seen it came Up with Brake Light Indication Output Short circuit to ground. What does this mean and what do I have to replace or fix so this code is cleared?
Take your battery cables off for 10 minutes and hook them back up. This will reset the computer and clear the codes. If it stays popped up, the bulb for the abs system in your dash cluster is burnt out.
Posted on Mar 02, 2015
544 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions