1987 Dodge Aries - Answered Questions & Fixed issues
Car was running great,cut right
There are a couple of issues that can cause this. Dodge use a double fuse system for the fuel pump. One fuse is located in the interior fuse panel, mine was in slot 13 but that was a Neon. The other fuse and relay are located in the engine compartment in the power distribution center. Now, having said that I will tell you the bad news. If the timing belt broke, a definite possibly in an 87, the fuel pump is shutoff due to a safety. Check the timing belt. You should be able to look at it visually through the cover and tell if it is turning. It will take two people if you don't remove the cover which is help in place by 2 bolts on a 4 cylinder. Before you go getting into all of these fuses and wiring use a multimeter to check the power wires going to the fuel pump AT the gas tank. If you have power there and the fuel pump isn't working then the fuel pump has gone out.
86 dodge Aries with 24
Code 24 will stay for 50 or so starts, but 52 is indicating a rich mixture. Possible oxygen sensor faulty. Clean connectors on oxygen sensor, and clean and check map sensor connection as well. Stop at an Autozone or Pep boys or similar parts store and they will scan and erase codes for you. Then see if code returns.
Why wont my reverse lights
Hello,
if your reverse light don't stay on, first check the bulb.
If the bulb is okay, check the reverse light wire and make sure its intact.
Lastly, check your fuse box. You should find your fuse box under your steering and or inside the bonnet. Check if the fuse has blown.
Good luck.
I paid yesterday for my question i recieved about
Check to see if it's fire or fuel. Take one spark plug wire off and put on spare new plug, Place spark plug on engine where the tip is grounded against block and while someone trys to start car check to see if there is spark arcking between tip and insulator on plug. it,s best to do this in the dark. if it sparks, try putting a little gas in intake then try to start if it starts or trys to start, yo know it's a fuel problem. Change fuel filter first, f no change check fuel pump. If no spark check ballast resister on firewall or fender
How to add break fluid
Remove the master cylinder cap and just pour it in to the respective mark on the reservoir. Some may not have the mak on the outside so 3/4 full is good enough
Water leaking
on the front of the engine behind the accessory belts .
Not finding what you are looking for?