20 Most Recent 1995 Dodge Ram - Page 8 Questions & Answers

try a new sender for oil pressure

check the fuel pump

You can place it anyway you can get the center bolts to fit. If it can only be installed one way it will only fit one way with all the bolts.

Have you checked the engine codes? On your 95 ou can by turning the enigne switch on and off 3 times quickly and then back on. Do not start engine. Then count the flashes to get any codes out of the computer. You can find the codes by searching the internet easly.

Go to your local auto parts store and purchase a repair manual with the wiring schematic in it. It will show you the exact wire you are looking for. When replacing it purchase the same guage & color wire so there will not be any problems or confusion if later repairs are needed.

Not sure about the 95's, but on my 04 dodge ram the interior lights went out, and the dash lights, and I about pulled my hair out trying to figure it out. After a year of driving around in the dark I finally brought it to the dealership. It needs a whole new instrument panel. There is a module built into the instrument panel that controls the lights. When it goes bad you need to replac the whole damn thing. Heres the kicker, the mileage is also built into the instrument panel, so the dealer charges about a grand to get the part with the correct mileage and fix it. You can get one on ebay cheap, but its illegal to tamper with the mileage, which is also built into the trucks computer. Installing a new part will not sync the mileage. On the other hand, your is only a 95, you may be able to just replace the dimmer switch, I did that on a 94 hyndai excel and it worked. Hope this helps. If anything get a tough light and some duck tape.

You should see if the vent near the heater core is stuck. I had that happen once. It was in the position for the AC so it wasnt pushing the heat. plusthe vaccum line that operates the valve could of broke / rotted.

Some cars/trucks have fuses in both the engine compartment and in the vehicle also. The ones in the vehicle should be located below the steering wheel somewhere. The ones in the engine bay should be in a black box on either the passenger or drivers side fender.

Tough one to try to fixe over the internet... my first impression would be air leak on the intake, or a fuel pressure issue.. or even maybe a really bad air filter, youve ellimnated spark issues with good idle, and replaced everything that adjusts fuel mixture.. it sounds like a simple problem right under your nose, dont give up!!

Could possibly be the ECM or computer it may be the crank sensor. The crank sensor is probably the cheepest so I would start there. Since it sound like you may be throwing parts at this, since you cant drive it to have a diagnostic done and you can't have the crank sensor tested, I would buy a used one from a junk yard to see if that is the problem to save a little money since you may have to buy somthing else if that does not work. Good luck

Go here and put in your info. They have a broad selection and great service.

http://www.crutchfield.com/cgi-bin/autoinfo/autoinfo.asp?lp=%2fapp%2fCar%2fMyCar.aspx

The filter is located in the fuel pump module, on top of the fuel tank

Inside the fuel tank. Normally you only replace it when you replace the fuel pump.

can not find gas kill switch for 1996 dodge ram 1500

remove wheel,brakes,rotor,axle nut,wheel bearing then the axle should pull right out

AAMCO gives free esaments and will show the problem

check fuel pressure