20 Most Recent
1999 Chevrolet Lumina - Page 6 Questions & Answers
Turn signal and break light
Make sure all the bulbs are working in the turn signal. Some front turn signals will use two or more bulbs per side. If any one of these bulbs are burned out it will cause the turn signal to flash at a fast rate. It also could be a bad control lighting control switch a.k.a. multi-function switch.
I have a 1999 lumina, the dashboard lights and the
I think the fuses are done. Check your manual or go on internet and find the fuse position of what is not working in the car!
let us know! You need a tool to check fuses! Hope you know how!
good luck!
I need to where is the freeze p[lug located and what do it look like
The engine block and heads have round holes in them to let the sand out of the casting when the engine was manufactured. Those holes are closed with a steel plug hammered in. Since those plugs are exposed to engine coolant they will rust and fail at some time. special tools have been designed to remove and replace them. It's not an easy job.
Replaced ignition switch 2003 chevy impala and car will not start
After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive
Car cranks but will not turn over
What? If the starter motor is turning over but not engaging the engine, You have a bad Bendix drive in the starter. Be more clear on what problem you are having.
Not finding what you are looking for?