20 Most Recent 1998 Chevrolet Venture Cargo - Page 7 Questions & Answers

the window may be off track. take the door panel off.

it may be the harmonic balancer

take the whole wiper and see if the splines are stripped.

Never less than about 10lbs.usually 30lbs or so  If less then either engine main bearings is badly worn or  or the relief valve inside the oil pump is stuck in the bipass mode.

there are 3 possibilities that I would check first. 1: make sure the contacts on the door, and body where the touch are clean. the lock and unlock signal are sent through these. 2: You may try replacing the battery in your key fob. 3: the power lock motors may have gone bad. To check, lock the doors with the drivers door panel, if they lock, they are fine. Another solution may be to recode your key fob. procedure for coding the fob to your vehicle can be found online.

yes it is, when you remove the heads have them checked for cracks
rate me & my solution

take seat belt loose at floorboard and check to see if anything is stuck in mechanism, sometimes the rachet spring will break and a ne seat belt is in order

were is the speeddometer sensor 98 venture

It looks as though you have to loosen the two engine rocker mounts located right on top the engine, take a rachet strap and tilt the engine forward while taking off the left part of the engine.

And where is it in the fuel system.

Unplug your MAP sensor. Located in air intake hose.

the battery might need replaced they might do it at wall mart. some of them use watch batteries. but I would guess dead battery.

Question edited to fix Fixya redacting a word it doesn't like. Question moved from Misc to model category. https://www.google.com/search?q=fix+the+petcock+on+Chevy+Venture ,,

It is on the fuel pressure regulator https://troubleshootmyvehicle.com/gm/3.8L/how-to-test-the-fuel-pump-1 https://www.2carpros.com/questions/chevrolet-venture-2000-chevy-venture-fuel-pressure-regulator--2 ..

get a gas cap their cheap

Its a long way from the gas tank to the engine so you need a fair bit of cranking. Also, if it ran dry, it means the pump also was running dry after it stopped. The gas lubricates and cools the pump, so you may have wrecked it. First thing, check that fuel is being pumped. Then check the pressure.

Before you start cutting wires it is worth you contacting the company who supplied the mirror unit and get them to recheck the one they sent you. 2005 was the last year they made the Venture BUT the LT trim level ended in 2004. They might have sent you the mirror for a vehicle that isn't for the LT trim.

Some fixya user told me a website reliablestore it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

hello u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

you can try out some guide from here reliable-store they also provide live chat fe ature for instant help and it's very useful