20 Most Recent
1983 Chevrolet K1500 - Page 2 Questions & Answers
1982 Chevy K10 Fuel Problems
Check to see if timing belt is broken. or wiring to crank-shaft sensor and check sensor itself on front of flywheel typically but may be on side of block usually the further towards the transmission is Crank and closer to front is cam sensor.
Check relays by switching from others of the same numbers.
Crank-shaft positioning sensor is bad perhaps.
Remove plug under vehicle that leads to fuel pump and check for voltage when key is turned on. if voltage is there is either defective fuel pump, was put in wrong or is harness from that point to the pump.
try banging the tank with hammer as someone turns key on.
check harness from fuel pump to where it goes into the body - remove from body plug and inspect.
Should be either and or both a fuel pump relay and fuse!
Run 12 volts to the positive side of the fuel pump wiring to see if pump is good. 3 wires usuallly 1 is ground for both the fuel guage and the other positive for the pump. and other is positive for the fuel pump guage and these two wires for the guage will show some resistance. put a fuse inline with the 12volts to the fuel pump positive but cut the line to the body prior to this - temporarily.
Could be bad switch in ignition unit in steering column but doubtful.
Hope this helps.
Did the normal battery, cabeles, in line
Check the power at the small terminal on the starter closest to the engine (right side if facing it) with the key turned to the start position. You should see 12 volts there. If not, check the neutral safety switch (or clutch switch) and ignition switch to make sure they are good.
Can i just soke the
The jets will come out nice and clean with some carb cleaner. The diaphram is a new one to me.
What is the towing capacity of a 1983 chevy 1/2
Hi, this all depends on what you are towing, and your hitch set up. If you have an approved towing package, it will be rated at 5, 000 lb's.plus. If you do not have a tow package and just a hole in the rear bumper with a ball, it should say on your bumper next to the ball the amount of weight you can tow. I have no tow package, but my bumper says I can tow up to 5,000 lb's. Do this, go to the u-haul web site, at www.u-haul.com and enter the information on your truck and the information that will come up for what you have, your truck, year, model, and make. It will tell you the amount of weight and what set-up you need for your truck. I hope this has helped you.
Shastalaker7
1980 Chevy Truck Brake Locked Up
There are times when the rubber brake lines start to come apart internally and act like a one way valve. they let the fluid in, but will not let it out.
Try this: The the brakes are locked up release the bleeder on the caliper. if pressure come out there, lock up again, and release the hose where it goes into the metal line. This may be hard because of rust, but you will probably have to replace the line anyway.
You may have a bad Master, but odds are it is the rubber lines. Hope this helps.
No head lights parking
Ha. An '83. Last of the foot mounted headlight dimmers. If yours is equipped with the foot mounted dimmer, there's your problem. I haven't seen this problem in awhile. Hope I've helped. Under 20 dollars new. Please rate my assistance and leave a testimonial to help others that may experience a similar problem.
What is the spark plug
These were still early times for the then new...HEI ignition...The factory was using a 60 mm gap...most mechanics used a 45 mm gap, as the 60 mm was proving to wide for peak performance...I highly recommend the 45 mm gap on your spark plug gapping tool...be sure the electrode is still perfectly straight with the tip when measuring...:)
Not finding what you are looking for?