20 Most Recent 2005 Chevrolet Venture - Page 2 Questions & Answers

Are you looking for the wiring or emission schematics?

It might have bent the tie rod and the tire is not rolling properly or the wheel bearing broke. Either will need replaced.

Could be the security system, key switch, neutral safety switch, battery connection, or starter.

Normal, these are called "daytime running lights"

Remove the old line get a length of straight 3/8" steel tubing from parts store and you must bend the new bulk line to the shape of the old line, you can also patch the old like where is damaged with rubber cooler hose (do not use fuel line)..

You could be low on motor oil or you could have sludge build up. You should change your oil regularly. -------------------------------------------------------------------------------------------Multi-cardiag M8

Both "blower" fuses are fed by the ignition switch. If there is no power to those fuses than the switch is the likely problem. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

shift solenoid for second to third is bad about 45 bucks and some mess located under the tranny pan

I guess I should start by saying the code did not say the sensor was bad. It probably said the sensor signal was out of range.If replacing the sensor fixed the code but the engine still runs rough and stalls, it could be a leaking injector or a problem with the throttle body.You would need to know which cylinder is causing the miss.

Use a flat screwdriver under the hose where the clamp was, try to get it loose from the plastic housing, they are in a tight space and very difficult sometimes. Use lots of force and it will give up.

would like to hear this noise please

is it the fan knob or hot/cold knob that doesn't turn well?

first does he have battery cables tight and in right spot red cable goes to pos on battery and black cable goes to neg on battery and make sure nothing came unhooked or broke or loose on eletrical box

60-65 PSI

You may be on the right track on the clogged or restricted return line. One thing though are you using E85 fuel?