1984 Chevrolet Corvette - Answered Questions & Fixed issues

It may be underneath the middle of the front bumper. A metal pull lever.

Your better off getting qualified tech to do a waterpump.Replacement if you dont no how to do it.Youll cost yourself more headaches and money.Qualified mechanic here giving my time free

That depends on if you have it installed correctly, If so take a look at this video.....should cover all you need to know https://www.youtube.com/watch?v=0ZFMtaZVmWI

In a nutshell, you disconnect everything attached to it and slide it out the passenger side between the subframe and frame. Obviously, you have to disconnect all of the fluid lines, the tie rod ends on both sides, and the 2 (or 3) bolts that holds it in the car, along with the steering shaft.

Try to remove the belt for the ac and see if you still hear the noise, as it sounds like you may have blown the seal or bearing out of the ac compressor , not sure just a guess.

Most likely the fuel pressure solenoid not building up enough pressure in the fuel rail. Good Luck :)

Depends on if the fuel pump is inside the fuel tank or outside. Outside tank less than 1 hr. Inside tank 2 plus hrs. Dis. Cap 15 mins Coil 15 mins

Not sure what the question is, but check oil with engine off. Remove, wipe, re-insert and check.

Here's a link peter. 1986 Corvette Fuel Pump Relay replace

Alternator, starter, radio or interior lights. Main four things that draw power for 84's Could also just be a bad battery.

It may have something to do with bushings and the overdrive unit. Also , there may be a problem with the release on the shifter.

i do not know but give these guys a call they sells only GM-parts its Schram auto & truck parts 1-800-292-1032 and they website is www.schramauto.com wish you the best of luck Michigan Man.

You might want to look at what Borla has to offer. All stainless, performance tuned and nice sound, but pricey. The good news is it will last darn near forvever.

I recommend going to your public library and looking at a Chiltons or Haynes manual for your model

I would recommend going to your library and looking in a Chilton's or a Haynes manual

Sounds like the ignition switch isn't contacting correctly. How do you turn it off?

Either buy the factory exhaust or (cheaper) custom built.

You can remove and carry back to dealer to have repaired,I had to on my 89 Jimmy, cost was 300 ,4 years ago, but they give a 1 year warrenty.

Remove the center console, you will see the little orange tang which should be attached to the shifter, sometimes they come loose, re-attach it to the shifter and you are done.

it's on the ecu which is under the dash up high on the passenger side.