20 Most Recent
1998 Chevrolet Blazer - Page 9 Questions & Answers
Leaking from the front diff on a 96 s10 blazer
That would depend on where on the diff. the leak is coming from. If its leaking where the driveshaft connects to it, then it's a pinion seal. If it's leaking near the wheels, it's an axle seal, and if it's leaking where the cover is, it's a bad cover gasket. If it's the cover, you can reseal it with RTV gasket maker.
How do I change blower motor in 2003 Saturn ion 3
I had the same problem with my 02 malibu. Most of them are located on the right side of the car, right under the dash. Most of them are very easy to swap out. When you look under the dash, you will see the compartment and should be 4 screws. take those screws out and remove the old fan. Replace it and you will be on your way. This is usually a very easy and cheap fix.
My 1999 chevy blazer wont shift out of low
My husband had the same problem with his 1988 S10 Blazer. We drained the tranny, cleaned out the pan and put in a new filter etc. Filled with new fluid and all problems solved. Shifts better now then before the tranny service.
4x4 inop
Check underneath for interferences, etc. Look near the transmission. Those transfers had a bad habit of wearing our the splines. You made need a replacement.
My 1998 chevy blazer has been having starting
the only way to know for sure is to test fuel pressure. The test port is on the fuel pressure line on the back side of the motor near the distributor. You should have at least 57 psi of fuel pressure. Anything less and it will not start.
If you have no fuel pressure than you'll want to check for power of the fuel pump. You should be able to find a spot where you can access the harness as close to the fuel pump as possible. You'll want to probe the large diameter grey wire. It should have power for 3-5 seconds as soon as you turn the key on and anytime the key is in the start position.
Another thing you can try is spraying a little carb spray down the throttle body. If it starts and runs than this is a classic sign of low fuel pressure. The injector poppets require high fuel pressure to open when you start the vehicle. When the vehicle is running the poppets are under vacuum and require less pressure to work. I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
Blend door actuator
bad vacuum actuator or vacuum leak to the vacuum solenoids that operate the blend doors.
Not finding what you are looking for?