20 Most Recent 1989 Chevrolet C/K 3500 Questions & Answers

Hello friends you can getting the online here information way to use easily remote desktop on your computer to connect to a windows on the system here the best option to given the commend for windows 10 remote desktop connection thanks for the follow the our site online get the best IP address to use the best connection for web users. http://remotedesktopwindows10.com/

I haven't tried this but I saved it..Sound like your computer needs resetting.. Especially doing all of that..

hi shannon. not sure if this link will be of any use but have a look. 1989 K3500 7 4l will not start Google Search

where can i find the fuel pump on a 1988 fleetwood southwind

the wires the do the charging are on the alternator. the only thing the goes to the dash would be the wire showing that it is charging and that is not important. if you go on autozone.com. register and they have wire diagrams you can view. that's if you know how to read them. some are a pain

The switch only sends a signal to the wiper motor. If you lost the intermittent part, replace the motor.

drivers side lower dash follow this link to a fiat coupe forum for further advice etc What your fuse board like Fiat Coupe Forum

The base timing on this truck is 0 degrees in drive with the est connector unplugged. I set them to 4 degrees BTDC MAX. but you may a issue with a slipped balancer remove #1 spark plug slowly turn engine clockwise with a coat hanger in the plug hole you can feel the wire come up to TDC then it will start to go down your balancer line should line up at the point of no more movement. These engines also need good fuel volume and pressure about 10-12 psi check fuel filter also.

Sounds like you snapped an axel.

in bottom back plate there is a slot . Try to turn adjusting screw .

Replace the Throttle Position Sensor (TPS)

Not sure on what you are asking here. Could you give more details please........

Check the bulbs Check the brake fuse. Check the brake switch. The switches located on a bracket above the brake pedal. There should be one wire with powe're all the time. There should be another wire that has power when the brake pedal is depressed. If none of the other wires power up with the pedal depressed than the brake switch is bad. I can get you wire colors if needed. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa