20 Most Recent 2004 Chevrolet Venture Passanger - Page 10 Questions & Answers

Yes what doesnt show on the outside is loose contact on the inside

Sounds like your fuses are out... no power to the control panel? It sounds like you have a fuse problem. Try and check your fuses and connections.

Not sure about your particular model but most GM vehicles have a module on the wiper motor and if it fails it will cause your symptom and it is a common problem. You may have a bad wiper switch also. You would have to do some votage tests at the motor to eliminate the switch being bad.

This car uses a type 4T65E automatic transmission

There might be problems with the wiring. Have it inspected. It might be grounded. You may want to check the relay as well.

take the front motor mounts loose and lift on the transmission pan with a jack and a block of wood, this will cause the engine to rotate forward and allow for more clearance

fuel filter is under the van on the inside of the frame, it may require special tool to unlock the fuel lines, its a round canister about 4 inches long .has a clamp and bolt holding it to frame. should be changed with every tune up.

This is a social chat room or web site,
not a repair shop or parts warehouse

Your problem is going to be the wiper resistor. It is located on the passenger side under the dash. Click this LINK to see what the resistor looks like.

CHECK THE FUSE,S SOME THEM ARE RELAY FUSE,S

BETWEEN THE BATTERY AND THE FRONT GRILL LOOK AND YOU SHOULD SEE A PLASTIC WEDGE WITH A BOLT IN THE CENTER REMOVE THE BOLT AND THE WEDGE AND THE BATTERY SHOULD COME OUT

Wath seal in wath place in engine?

there are 2 or 3 screws at the outside where the base mounts. If you cant see the screws then the cover has to come off to get access to the screws probably torx. remove the two screws unplug the electrical connector and reverse the process to mount it make sure the screws are going in straight dont strip if it is machine screws

From the dealer or a salvage yard

section it and use hose clamps. not muc pressure there.

http://groups.yahoo.com/group/villagerquest/

Failed seat heating elements are fairly common. I have also seen several failed seat control modules. Access to the data from the Body Control Module and the Seat Module is necessary to perform an effective diagnosis.

Here's a great video that will show you exactly hos to remove the headlights in your 97-05 Chevy Venture">

if you have the owners manual I think you can do it on the radio

While engine cold, open your radiator cap, start the engine then engage your throttle to ramp up/down your rpm from idle to 2000 or higher for about 15 seconds then top up then coolant. Repeat the above steps 2-3 X. Or after replace the coolant, just do short trip/travel with your car, after engine get cold, top up your coolant to normal level. Now your radiator is free of air. It is easy.
Regards, Jay

There are nuts on the wiper arm posts under plastic caps[ if still there ] they looen sometimes and the arm won't move turn off the wipers so the 'park' and check the nut for tightness - should be quite snug. it that dosen't fix it then you have a linkage problem from the motor.