20 Most Recent 2004 Chevrolet S-10 Questions & Answers

always turn right

Bad vibration

sounds like the shift motor on the transfer case is going bad.

turn it up

time for a new button.?

If the heater door controls are vacuum operated, you will have a hose from the engine enter the firewall and go to the back of the heater controls, where it enters a connector with several hoses going to places on the heater case where they work the doors by actuators-diaphragms that retract with vacuum applied causing doors to open or close. Begin with ensuring the vacuum hose from the engine has vacuum at the back of the heater controls with engine running-just pull off the right hose and check for vacuum-the hoses may be color coded to help you. If you have vacuum there, reconnect that hose and move to the actuators on the heater case, check if vacuum signal is routed there. Check the actuators for proper operation-sometimes they fail. And sometimes things that fall into vents get caught in the doors and jam up. Good luck, hope you find the problem.

open the center console, there is a bucket in there, pull straight up on it and it will pop out of the console "frame". There is a open hole under it, there is clips on the sides of the CD disk case holder, push on it with a flat head and it will pop out.

possible wheel bearing at fault. if it heard/felt more when turning or swerving and is a growling type noise, more than likley is. possible bad tire shouldnt be over looked. is abs light on? most often when wheel bearing is bad a speed sensor ( within wheel bearing ) will go open, setting abs light. vehicle needs to be ran on a hoist to try and duplicate noise/vibration.

try a regular cd cleaner like you would use at home, it works the same way. Those GM stereos have a lot of problems, if you care to keep it and cleaning it doesn't work, there are places around that can repair it or you can get a used one at your local salvage yard

There are many different types of CD lens cleaners on the market. Get the best you can afford and try it. If a heavy smoker owned the truck before you, it could have a film on the lens. It might remove it, it might not. The lens can be cleaned with denatured alcohol but, if you don't get all the residue or film off, or scratch the lens or get the head back to the proper start position, it still won't work. Either way, you will have a good cleaner for your home electronics.

Drill out pop rivit & install a small bolt witha nyloc nut

In relation to this problem,there is help link provided below.Click the link below to go through its procedure to troubleshoot the problem :----------http://howtobyme.blogspot.in/2012/02/heater-blows-only-from-defrost.html ---------This will help.Thanks.

What do you mean it freezes up ? what is it doing ?Does it crank or does nothing?Need to know more info

First try disconnecting the battery for about 10 minutes. This will reset all of your electrical systems and perhaps fix the issue.
If this doesn't work then check the 4 wheel drive transfer case electronic module in the right kick panel on the passenger side for corrosoion. If any posts are broken are burnt they will need to be replaced.