20 Most Recent 2004 Chevrolet Blazer - Page 6 Questions & Answers

Do you have a code scanner? What code does it give? If you don't have a scanner and the car is drivable take it to an autozone and have them hook it up to the scanner to get the code or you can buy a cheap scanner for $50 if the blazer was not running rough before you may have not pushed a plug wire on completely and now the engine is misfiring on that cylinder. how many miles on blazer? the platinum plugs from should be good for 100K miles.

Sounds like there is a broken rear HVAC actuator for the rear HVAC. There should be two of them. One for the mode, one for heat / a/c control. Pull the trim panels in the rear and when it's making noise feel the actuators. You should be able to feel the one that is making the noise. The next step woul be to remove it and make sure the door it controls moves freely. It it doesn't you have bigger problem. If it does replace the actuator and you should be good as new. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com! I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Many a times the problem occurs due to timing not adjusted,in many cases the timing belt also needs to be replaced while water pump replacing.Or its also possible that water pump not replaced properly or timing got mistimed.I suggest you to check few help links.-----------

For water pump replacement i suggest you to check the help link provided below.

click the link below :----

Water pump replacing procedure for all vehicles?

http://technoanswers.blogspot.com/2011/11/water-pump-replacing-procedure-for-all.html ---------

HOW TO REPLACE A WATER PUMP

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-water-pump.html

------------------ How to route Water Pump Belt for 1992 Oldsmobile ?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html

--------- How to replace Water Pump on Car ?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-water-pump-on-acura-car.html

--------- How to Remove Water Pump?

http://technoanswers.blogspot.com/2011/12/how-to-remove-water-pump-on-toyota.html

------- Where is Water Pump located ?

http://technoanswers.blogspot.com/2011/12/where-is-water-pump-located-on-toyota.html

-----------

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models? Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html ----------

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks

this vehicle has an electronic speed sensor located on the trans i do believe but im pretty sure this is your problem change it and your cured

Thermostat and housing is located on driver side of engine directly under and to the rear of the A/C compressor. ( this comes as a complete unit ~ $ 30.00 usd.)

trucks cars

i always check the fuel filter first thing. you might have clogged filter or water in the gas

There is so much turning up there that it can be several things. The normal Balljoint problem can have the part slip in and out of its socket if it gets loose. Check your tierod ends for slack. Sometimes Calipers can rock if they are failing to float properly with loose hardware. The front torque is changing from being pushed by the rear wheels to pulling with the front wheels. This can affect how the Balljoints react as the sockets are getting torque differently than in 2WD. You are also using the CV joints to pull rather than coasting in 2WD. Check your end play for the front hubs; they used to be about .005 and you need Year model specific Specs to be sure.Check out some 4-Wheeling Blog sites as they may know more about the common problems. There are so many things to check that a Blog may be your best source.

Is the key to air-condition works , a/c light come on . let me know .

In the fuel tank

year, make, model, I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

they are correct in saying that the ABS will not function when the ABS light is illuminated.

Did they tell you what the problem was?

Many parts are available in the aftermarket. So if you let me know what they found or if you know what the problem is I would be happy to see if I can find them for you.

If you don't know what the problem is than the first step would be to pull codes form the ABS module. You will need a higher end multi-function scan tool to do this. Once you know what codes are present you will have a much better idea of what is going on with the ABS and I will be able to help you further diagnose what the actual problem may be.

Let me know what you find and we'll see if we can;t get this figured out. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa