20 Most Recent 1995 Chevrolet Impala Questions & Answers

Watching the picture of the car.I think that the engine is a V8,don`t remember which side of the engine but in the top of the valve covers you are going to see a hose that comes from the carburator or TBI,at the end of that hose goes the PCV valve and inserts in to the valve cover.

Let me get this straight. You cannot take it out of park and go to reverse, or you put it in reverse but the car will not move when the fuse is in.

get a chiltons book If you need further help, reach me via phone at https://www.6ya.com/expert/scott_8b3f0f0fc5f566a7

What type engine? I assume if it is opti-spark it is a v8. L type .Check the routing of wires. GM vehicles are very susceptible to cross fire . Opti-spark distributors are notorious for failure as timing is achieved by a laser eye reading slots of a rotating disk and sending that data to the pcm. It was GM biggest failure. Check the installation especially the cap. Voltage will fluctuate anytime and engine's timing or firing if not on point.

You need to stop--have a drink--get on utube

https://www.google.com/search?q=2008+dodger+ram+belt+diagram+i+can+print+off&biw=1366&bih=651&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwjUoMiB4LPQAhWINSYKHeQ1CQ8QsAQIGg#tbm=isch&q=Is+there+a+fuse+for+the+power+antenna+on+my+1995+Chevrolet+impala Hope this helps

18436572 or the left bank 2468 right bank 1357 on the distributor left bank 2864 right bank 1735

The digital speedo is repairable. The issue is, the contacts of the display are no longer making good contact with contacts on circuit board. A good gauge repair service should be able to rectify the issue. Good luck. Ron @ Speed-O-Repair.

I believe 92 to 98 on your transmission. GM put a lot of those transmissions in cars. You just have to get one with the same engine size as yours. A salvage yard should be able to tell you..

Unless you have a LOT of experience modifying cars, you BETTER stick with the manufacturer model of transmission that was already on the car. Some older GM's you could swap out / upgrade transmissions for small-blocks (like replace the 200-metric with a 350-Turbo <HIGHLY RECOMMENDED>, or upgrade the 350 Turbo to a 400 Automatic <check to make sure your car make/model will have enough clearance to allow this>. Fords & Chryslers are not near as forgiving, however. For most of those automatics, stick with the original model type that came with the car. BUT DEFINITELY CANNOT CHANGE DIFFERENT MAKE + MODEL CARS' TRANSMISSIONS (they are NOT interchangable).

Have to know your transaxle unit model Then find a similar one NEVER,NEVER,EVER install a USED PIECE OF JUNK, worse than the one coming out

ok,go to advance auto parts,they sell a do it yourself kit,the store salemen will show you on your car where to put it in,he may do it for you,,AND ITS FREE FOR HIM TO DO IT.

http://www.gmtruckclub.com/forum/showthread.php/30334-GM-OBD1-DTC-codes-for-1995-and-older have a look to this link,, hope it helps