1994 Chevrolet C1500 - Answered Questions & Fixed issues


Assuming the engine has not siezed, there is a short in the starter circuit. Probably the starter/solenoid, but you can verify. Disconnect the negative battery terminal, then the big red wire from the starter solenoid. Wrap the wire terminal tom prevent shorting, reconnect the battery terminal and try again. If nothing happens this time, replace the starter/solenoid. If short is still present with starter unhooked, trace wire back from starter to find short. Let me know if you have more questions.

1994 Chevrolet... | Answered on Sep 29, 2018 | 151 views


If you have not worked on a 4L50E transmission before, leave it to someone who is familiar with the the 4L60E. The solenoid is in the valve body and i know some who have put things back together and needed to take it apart again over something simple as a servo pin in revers. Best thing to do is get the truck scanned at Auto Zone free of charge or at a transmission shop with a tech 2 scanner for DTC codes. If there is a bad throttle body sensor or it's misaligned, it would affect your transmission's performance. The throttle body sensor send's signals to the ECM which calculates the amount of transmission fluid pressure though out the shift points, if that signal is bad then your shift points and firmness will be affected. There is also a cheap and great performance upgrade for around $50.00. You have a Transmission shop swap out the servo's for a Corvette servo's, it can be done in 30 min with out taking the transmission down or removing the transmission oil pan off.
Recap, have the transmission fluid and oil changed and have the throttle body sensor tested. It should show a smooth gradual increase in resistance with out any fluctuation. You truck is 15 years old and it may have a dead spot on the sensor now and it may need to be replaced. Good luck and keep me posted, Be glad to help and you can also have the transmission shop do a transmission pressure line test.

1994 Chevrolet... | Answered on May 20, 2018 | 5,067 views


your shift silinoid is gone there is 2 inside the transmission

1994 Chevrolet... | Answered on May 08, 2018 | 69 views


You have to adjust the sifter rod that's in the engine compartment next the steering column .

1994 Chevrolet... | Answered on Nov 04, 2017 | 39 views


-Sounds like bad igniter. But make sure check fuel pressure as well.

Good luck

Mai

1994 Chevrolet... | Answered on Oct 25, 2017 | 37 views


Before you go tearing up the transmission. Check tp sensor (throttle position sensor). Keep in mind transmissions also have electronic parts that govern shift patterns . Signals sent to the truck's computer from sensors govern when it shifts. I would check sensors and wiring to those sensors first before tinkering with a transmission.

1994 Chevrolet... | Answered on Sep 19, 2017 | 50 views


Flush the system and look for contaminants. If there is a bleed on the proportioning valve, also flush there. If there are contaminants, your master may need to be replaced. If not, maybe the proportioning valve has failed again.

1994 Chevrolet... | Answered on Aug 04, 2017 | 54 views


The only thing I know of, on a gasoline engine, that will bite you is secondary ignition voltage. What about your ignition coil? If the vehicle will run, raise the hood in the dark, look for fire/spark jumping around.

1994 Chevrolet... | Answered on Apr 28, 2017 | 28 views


How long since a tune-up? Are there any applicable trouble codes?
If your saying, no spark at the spark plugs. Check the cap--rotor--spark plugs and wires, check the coil. Check primary voltage at the coil goes hot with key on.

1994 Chevrolet... | Answered on Apr 05, 2016 | 37 views


If it starts and runs when you add gas manually then you have a fuel delivery problem. Check the fuel pump relay and check the fuel pressure if the relay is fine. You might also have someone turn the key in a quiet environment while you have your ear close to the gas tank area and see if you hear the fuel pump run.

1994 Chevrolet... | Answered on Mar 27, 2016 | 49 views


c1500's are a two wheel drive truck, a k1500 is a four wheel drive truck? i dont know what you are asking

1994 Chevrolet... | Answered on Jan 26, 2016 | 67 views


Fill at side fill hole until fluid begins to run back out. Let it run until it stops, install plug and wipe up excess. If fully drained, usually holds less than 3 liters.

1994 Chevrolet... | Answered on Sep 02, 2015 | 187 views


Do you know anything about wiring and newer door units? If you stay with your year, you could probably get power windows. If you want it all. You need schematics or your year and the year going in, you will also need a BCM for the year going in. and most of all You WILL need patience. Lots of wires to power up and cut and splice into. You buy the schematics years and BCM and post them, I will help you threw it. If you don't know, I wouldn't recommend doing this for your first time. You can waste a lot of money and still have a non working doors.

1994 Chevrolet... | Answered on Aug 18, 2015 | 57 views


i have no product knowledge here of this vehicle but 2 part asbestos type seals went out with the ark so i would imagine this is a rubber seal and easy to change ,after the gearbox has been removed ---- the hard part

1994 Chevrolet... | Answered on Aug 17, 2015 | 1,716 views


undo the fuel line where it joins the fuel rail to your injectors.. it is under extreme pressure so be careful.. get someone to crank car for a second or two and if fuel sprays out then its not a fuel problem..

1994 Chevrolet... | Answered on May 06, 2015 | 664 views


maybe it is old and worn out

1994 Chevrolet... | Answered on Apr 12, 2015 | 67 views


Most likely this is a brake light switch issue. Replace switch.

If your emergency flashers don't work, all flasher bulbs are fine, but flashing too fast, then check and replace Hazard light switch.

1994 Chevrolet... | Answered on Apr 04, 2015 | 1,523 views


Not as long as the dirt is on the outside,,,,,, take every precaution to make sure dirt never gets on the inside

1994 Chevrolet... | Answered on Mar 28, 2015 | 26 views


Use a shop vac and suck it all clean, the entire area even down every port, and next time blow the engine clean with compressed air or even a water hose before you begine

1994 Chevrolet... | Answered on Mar 28, 2015 | 26 views

Not finding what you are looking for?

846 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...