1992 Chevrolet C1500 - Page 9 - Answered Questions & Fixed issues
Wiring diagrams
I suggest visit autozone.com (free register).
Good luck, and remember rated this help.
92 C1500 Chevy wont start. Changed plugs, wires,
So you threw parts at it. No harm intended. Should have started with the adding gas part first. You know the filter is new and it does run! Are the fuel pump amps correct,pump mech bound,no fuel volume, pressure regulator work correctly? Does the pump run in start mode or time out? Now the harder stuff. What does the spark and timing look like,What is the computer seeing and then what command is it sending?
Have a chevy 350 TB and it does fine in park but
Are you getting a check engien light on in your dash ?
You should have a OBD II reader plugged to retrieve any codes to help figure this out.
It could be about 6 different sensors ect.
Please let me know.
How doe i put a head gaskit in my 1992 chevy
Lots of work. Best bet get a Chilton manusl covering that year from the library or Ebay. Real quick disconnect battery, drain coolant, remove intake manifold, remove any accessories on the side of the engine you're working on , like compressor. Remove valve cover, loosen all valve rockers, remove all 8 push rods, remove head bolts, pull head. Lots of smaller stuff I skipped. You will definately need the specs to reset valve/rocker, torque values. Gasket set, change oil because there will be water in it. Better have a friend who has tried this before too. Can be done but it's tough to do the first time.
Truck has no fifth gear
not unless fifth seases to the baring's. but then it won't even go in to 4th or 5th. it's probably your sincro's that r bad between 4th and 5th.
No display on heater a/c 92 chev
behind the glove box there is a fuse, was told this by a person i asked on KIJIJI.CA so I could not find the fuse yet I ran a hot wire from the batt to the big orange wireon the head unit this solved the problem
so now its my mission to find the fuse , and its all good now
What do i do?
Check for tension in the drive belt. A loose drive belt would cause hard steering as well as eventually, would drain the battery. If the drive belt is in good condition (no slick or broken spots) and is tight, then the problem is more likely in the steering box.
Where do i put power steering fluid in my 1992
The power steering fluid goes in the power steering pump which is on the drives side of the motor below the alternator.It is black and has a twist off cap.The cap is a dip stick type.It has levels which will have a hot and cold level.If the engine is cold fill to the cold level.If it is hot then fill to hot level.Hope this helps.
My 1988 chevy v-6 pick-up has been parked for 6
I would have someone get on the ground back behind the truck underneath the gas tank and when you turn on the key, you should hear a hum as the fuel pump primes. You could also hook up a fuel pressure gauge on to the schrader valve and see if has the correct pressure or if you get any at all and whether it holds it. If you don't get the correct pressure or it doesn't run at all, then I would say it is the pump. Depending on what fuel system you have you will have different pressures.
Can i take a 1992 full size blazer body and put it
If memory serves frame length on a CK10703 is about 121" and on the Blazer is about 111".
Can it be done? Anything can be done, depending upon how much work you'd like to do and how much money you want to spend.
How do you change a fuel pump on a 92 chevy pu
You will need to either take the bed off of the vehicle or drain the fuel tank and drop it on the ground while layin on your back.If you have a couple buddies to help you out then the taking off the bed way is much easier especially if this is your first time doing a pump like this.Please do get back to me if you have any more questions...thx..jay
Not finding what you are looking for?