20 Most Recent
1991 Chevrolet S-10 Blazer Questions & Answers
Had a solution posted on
You have to count the flashes. It repeats each code three times. Those flashes are the number codes. All of the codes are two digits. One flash is '1', then short pause and two flashes would be '2'. Since the codes are two digits that is a code '12' and it repeats that code two more times and then starts with the next stored code. It always starts with a code '12' to let you know it is in diagnostic mode and the last code is always '12' to let you know it is done flashing codes.
My brake light is on in 1991 s10 blazer
its vary simple open the hood facing the engine too the far right op to the fire wall witch is all the way to the front on the right hand side you will see a clear plastic bottle with a black top on it you will see the fluid level though the container if you don't see any fluid in it than you will have to have the brake system preged for air in the system. witch is a kinda big deal if you are not mechanically inclined but if there is still fluid in the bottle just buy some dot 3 brake fluid take the cap off and fill it up its that simple hope this helps LARRY B
Digitl dash problems 1991 blazer
try this website reliable-store.com
they help you with all this stuff, ask the girl at the bottom for help
they give manuals under like $10 and it's very useful as well
must try
1998 Chevy S10 pickup backup lights don't work
Yes it screws in on right side of tramission and you will need a 7/8 inch deep socket to remove it. You may be able to clean the old one once it is removed. There is a little ball thatgets dirty and may you can get by with cleaning it. Good Luck. Ed
Not finding what you are looking for?