20 Most Recent
2003 Ford Explorer - Page 6 Questions & Answers
4 x 4 light keeps blinking
Something that may help is to reset the computer in your vehicle.
Remove neg and pos (in that order) and touch the two ends together for about 30 seconds or so.
No sparks will fly. What that does is "restarts" your system computer and puts it back to zero.
Hope this was helpful.
5/26/2016 12:55:27 PM •
2003 Ford...
•
Answered
on May 26, 2016
I JUST BOUGHT A 2003
All your gauges are working. The gas gauge Is also working. When you fill it, you will fill over the limit the fuel level switch will go by a couple of gallons. So the gauge will not drop for a few miles. until you use up the excess fuel
4/3/2016 11:42:37 PM •
2003 Ford...
•
Answered
on Apr 03, 2016
My coolant is rapidly disappearing,
IF YOU GOT TOO MUCH WATER IN COOLANT SYSTEM AND DONT HAVE 50 / 50 MIXTURE OF ANTIFREEZE AND WATER. WATER WILL EVAPORATE BOIL AWAY.CHECK FOR COOLANT LEAKS LOOK AT TOP AND BOTTOM RADIATOR HOSES LEAKS, CHECK FOR COOLANT LEAKS AROUND BOTH RADIATOR CONTAINER AND RADIATOR CORES LEAKING. CHECK WATER PUMP WEEP HOLE. IF LEAKING WATER NEED REPLACING, CHECK ENGINE CRANKCASE ANTIFREEZE WILL LEAK IN CRANK CASE OR LEAK IN THE INTAKE GASKET COOLANT WILL BURN WITH FUEL.MANY THINGS WILL CAUSE COOLANT LOST.
3/15/2016 1:15:44 AM •
2003 Ford...
•
Answered
on Mar 15, 2016
What does it mean when the light 'main. req. d' comes on?
Could be a lot of different things. If you're referring to the Check Engine light, it's probably a sensor or something similar affecting mileage or emissions. Easiest thing to do is to go to an autozone or pepboys type auto store and get a maintenance scan. They can tell you what is causing the light and what part is needed to repair.
2/9/2016 6:58:12 AM •
2003 Ford...
•
Answered
on Feb 09, 2016
Remove front door panel
simple really: locate window crank handle if equipped (non power) gently pry out plug from center use torx driver to remove bolt from center , use same driver to remove bolt from door handle well , and behind door handle (inside) then panel should be loose and lifting up (off lock pin) should move out enough to access plug (if power window equipped) if not panel should lift straight up . and off , mind the clips that are located all four corners (keep them) this should allow you to see the inside of door (plastic covering ) and see what the cause of window off track is , most times its cause is a door drain clogg and now rust has broken off the front mount point of glass rail
1/20/2016 8:51:57 PM •
2003 Ford...
•
Answered
on Jan 20, 2016
How to remove door panel
Usually a door panel will be secured by screws in a recess in the arm rest. Remove those screws.
Then, using a wide flat-bladed screwdriver, insert it behind the door panel and prise it free. Work your way around the panel, which is held on my plastic clips
1/20/2016 8:21:51 PM •
2003 Ford...
•
Answered
on Jan 20, 2016
2003 ford explorer xlt battery good but engine will not turn over
Keep in mind that the engine takes a lot more Amps to turn then it takes to light lights and open windows.
If it is as cold outside by you as it is here, a weak battery may not turn over an engine even with lights lighting and windows opening. First thing... clean connections at the battery
1/5/2016 6:59:30 PM •
2003 Ford...
•
Answered
on Jan 05, 2016
2002 ford explorer AC and heat blowing in dash, but very weak from the vents
On the motorcraft parts web site, you can blow up
a picture of the HVAC Blend Door Motors & locations,
as well as part numbers
You can get failed motor from Amazon
With knowing where the motors are located, try switching
the air flow modes manually, to see what positions do not work
Then you know what motors to replace
I also have professional scan tool software & can see the codes
for the motors in enhanced data.
The-- Vent Blend Doors-by name
Defrost-up top
Cabin -the vents as you say in the middle & on the sides
Floor
Recirculate-under the glove box
Blend Door -under the dash on your print
12/11/2015 9:36:07 PM •
2003 Ford...
•
Answered
on Dec 11, 2015
Not finding what you are looking for?