1990 Dodge Ramcharger - Answered Questions & Fixed issues
1990 Dodge RamCharger..... no overdrive one day
I'd suggest replacing the Throttle Position Sensor. It's about 30 bucks at Autozone, and only takes a minute to replace. You'll need a T25 Torx driver.. They also sell that for about 4 dollars.
10/31/2014 6:50:35 AM •
1990 Dodge...
•
Answered
on Oct 31, 2014
•
515 views
My gas gauge and my oil gauge to my 1990 ramchargerdoes not work?
replace the oil pressure sender first its cheep to buy
the fuel gauge can be hard to fix you need to get a diagram and ground the gauge wire if the fuel lvl gos to full then its the sender in the tank and thats a tank down repair sugjest replacing fuel pump whial in there
3/13/2014 3:54:01 AM •
1990 Dodge...
•
Answered
on Mar 13, 2014
•
197 views
Wiring diagram
In cavity 1, the 30 amp fuse has no power with key on? A wiring diagram shows that fuse gets power right from a wire from the ignition switch, with key on.
Wiring diagrams here:
http://www.bbbind.com/tech_database.html
You just have to agree to license agreement, go to "technical information". To TSB's and wiring diagrams: enter year, make, and model-make sure you are on wiring diagrams, not tsb's, then pick the diagram you want to look at. Every wiring diagram on your vehicle is available.
Rate if this helps you. Always appreciate a reply.
12/21/2013 1:04:03 AM •
1990 Dodge...
•
Answered
on Dec 21, 2013
•
962 views
My 4x4 on my dodge rancharger does not work
make sure your hubs are locked. the auto-hubs should be checked too for extreme wear.(if equipped) next look at the diff are all the gears there and not f'd up.put trans case in N and rotate front shaft, full turn with no resistance with hubs locked means diff problems. if shaft rotates in gear(any but N) and wheels off the ground, you have a Tcase problem(chain, shift linkage). so theres some things to think about.
11/4/2012 4:43:52 AM •
1990 Dodge...
•
Answered
on Nov 04, 2012
•
221 views
No fuel pressure
Is the pump running ?If so, and you know there is fuel in the tank, has the filter been replaced?
7/1/2012 4:24:27 PM •
1990 Dodge...
•
Answered
on Jul 01, 2012
•
66 views
1993 dodge odometer quit working
Could be either a broken speedometer cable if it has one, if not it could be fitted with the electric impulse type. In that case it could be loose/dirty or broken connections most likely to be underneath your car around gearbox propshaft/driveshaft. Hope this helps.
10/26/2011 6:44:12 AM •
1990 Dodge...
•
Answered
on Oct 26, 2011
•
152 views
Need help finding the ignition
The ignition module is integral in the smec. (single module elctronid controller) This is found on the left(driver;s) inner fender. These are pretty bulletproof units. Just curious to know what your complaint is.
5/13/2011 4:26:10 AM •
1990 Dodge...
•
Answered
on May 13, 2011
•
364 views
1990 RamCharger
The blinkers will
It is entirely possible that you have more than one issue.Perhaps you could fill me in as to whether the tail lamp issue and the turn signal issue occurred at the same time. For now a cheap remedy would be to replace the turn signal flasher as that is likely for the turn signals not remaining on. Let me know if this works....after this further diagnostics will be required.
2/20/2011 6:45:40 PM •
1990 Dodge...
•
Answered
on Feb 20, 2011
•
238 views
Not finding what you are looking for?