20 Most Recent
1987 Chevrolet V20 Questions & Answers
Fuel issues for 87 chvy v20 duel tanks
Verify power coming OUT of the switch.
Verify power at the valve.
No power out of switch replace switch.
No power at valve replace wires.
Good power to valve replace valve.
Good luck!
How do you replace the
Take off the door skin a couple screws in the handle and elbow pad then some plastic clips around the edges anad then it just slips over the top of the door dont forget to unscrew the door lock button. then you will see at the bottom of the door a few nuts to take off. I dont remember if you need to take the glass out or not.
Need to replace window and power window motor on a
Hi. Actually this is not a bad job provided that you purchase the motor and track assembly as opposed to the motor alone. Any auto parts store will have what you need. You begin by removing the interior door panel. If you break a few of the clips do not dispair as all auto parts stores carry them. The parts you need are all model specific, including the glass. That said, also call your insurance company as most folks have complete glass coverage. J.
1973 p20 Chevy van brake light not working
Check your fuses and if you have power coming out of switch when it is depressed.if that is ok check to see if you have power and ground back at the brake light sockets.if power is coming out of switch but not back at lights,look for open in wires also the brake light wires run thru the turn signal switch you could have a faulty turn signal switch.
1987 Chevrolet V20 purchase
It is important to do your research and know facts like the car value, retail price and car history before going to the dealership in order to get a the best deal possible. Details like insurance, warranty, and a fuel economy rating will help you compare pre owned 1987 Chevrolet V20 to other car models
I have a 89 chevy
The switch could be bad... there may be a replacement at your local parts store not sure of cost
Getting gas to carb but no gas to injectors
check your crank sensor and ignition module. you need a crank signal for your injector, to pulse, use a noid light to check at your injector for the signal or use a scanner. also a bad fuel pressure regulator, can result in low fuel pressure. Maybe the fuse for the injectors are blown? hope this helps!!! check to see if you are getting 12 volts to injectors.
Not finding what you are looking for?