20 Most Recent
1995 Buick LeSabre - Page 7 Questions & Answers
Battery goes dead, i mean dead.
u may have parasitic load what that is when like somethin on the car stays on even if u shut everything off causing to drain the battery
Why does my 1995 Buick La Sabre 3.8l v6 stall when it gets hot?
Does it restart after it cools a little bit?
If so, it may be a bad ignition control module. On this vehicle, I believe it is located on the lower front of the engine. If you're not sure of it's exact location, you can trace where your spark plugs wires go. They lead to the coils, which are mounted to the ignition module.
Check engine light causes
You need to put a diagnostic device on it to read the codes.
There is a reason for the light coming on and it could be serious.
You can buy the OBD2 devices from eBay fairly cheaply and then use Google to search for the error code/s associated with your vehicle.
Doing this will help you to narrow down, more precisely, the problem with your vehicle.
If you need to get the vehicle diagnosed in a hurry then taking it to an automotive technician would be a better option.
Assuming that you are able to get the vehicle there, and the technician isn't too busy, then they could tell you within a few minutes what the codes are and tell you what may be the cause.
until you know where to look, you could be throwing money at your cat without solving the problem, or its cause.
Climet control system does not work
HVAC
login to alldata.com and read the chapter
or buy the FSM>
or say what Dont work means. (no fan? or blower) or what?
lots of controls there, which work and dont, are the best clues.
Why to thebrake light flashed on and chimed
Please move set twilight slide bar to the middle. It's too sensitive and will do weird things like blink headlamps, tail lights, etc. It's a GM defect but moving the slide bar twilight switch should fix it. Good Luck.
Where is the1998 buick la sabre power steering reservoir
the 3800 v6 motors have the reservoir on the power steering pump - if looking at motor drive belt - alt on top of motor back toward windshield - p/s is at bottom of motor toward windshield - lean over motor or slide arm down around alt. - when not running and not hot - unscrew cap - funnel will be needed if fluid is low
Heater control unit stopped wrking , now stuck on high heat and fan
When I had my Buick we had problems similar to this and we just went to the auto wreckers and pulled one out of another car and replaced it and then it seemed to be fine. It's relatively easy to replace and a cheap fix, the unit cost us around $10 at the auto wreckers.
Fix blend door
Please let me know does move at all or if you try to switch it is it just blows air up on windshield?
Not finding what you are looking for?