auto zone says they cant read the codes unless it stays on car started stalling when at red light or stop sign 1992 buick regal 3.1 new plugs wired trans filter flush fluid oil change tires checked the coil pack help please!
Try putting somw SEAFOAM into your tank. It either your O2-sensor, or EGR-valve. Alot of the time, SEAFOAM will clean these sensor up????
Posted on Feb 07, 2009
my door opens from the inside just not the outside but it still pulls regularly
there is a linkage rod held by plastic clips that runs from the door handle to the door latch, it has come off, u must detrim the door to replace it.
Posted on Dec 16, 2008
1992 Buick Regal: power steering fluid leaking; cannot locate source, and cannot find a diagram. Source is somewhere behind engine; between there and wall. Help. It is spattering over the upper wall, etc. Leak is dripping to ground from center, behind the engine housing.
Fill it up. Have a helper hold the steering wheel to all the way to the stop while you check for leaks. Especially the high pressure hose.
Posted on May 04, 2009
My Sunroof will not work at all. The motor to the sunroof wont click over at all and its stuck open a little bit and leaks all over my driver seat. Was wondering if it was a problem with a blown fuse and where ti would be located in the car?
So is there a third fuse panel in a 01 Buick LeSabre
Posted on May 22, 2019
the digtal speedometer works but the analog odometer is not moving.
I worked for Buick from 90-93 as an A tech. The Regals and Cutlass had defective clusters. There is not much you can do other than replace the cluster. (is everything else working on the cluster?)
I had a 1990 cutlass that the odometer quit at 199000. I just kept driving it, or I should say my son kept driving it.
Posted on Aug 15, 2009
Replaced the driver side front ball joint lower after noticing a slight knocking sound over medium size bumps and being told it was bad by Monroe. Going over large bumps feels like front left of car is sustaining heavy casualties. Some of the knocking sounds in the suspension in the driver side front have disappeared after adding new tires and an alignment. Knocking sound is apparent even when braking. Front driver side caliper has a bit of play, but should stiffen when braking which I believe would not produce noise or knocking from the caliper. Therefore, when hitting medium size bumps hear a knocking sound above the caliper possibly somewhere on the strut tower. Top mounts are new also. Front strut assembly is approx 1 year old. Could this be a stabilizing bar issue or warn bushing or loose bolts in the strut tower? Please help, rattles and bumps drive me nuts. Thanks.
See if you can bounce car and replicate the noise. If you can, you should be able to find it, and put your hand on it. Stabilizer bushing are a place to look, both at the lower a arm and on the frame. If you narrow it down to the strut, it will need to be replaced. The front trans mount also goes bad, try putting it in drive with your foot on the brake and give it some gas and see if the engine moves an excessive amount.
Posted on Nov 23, 2009
buick regal 92 limited 3.8L 104000KM ,Major poor fuel economy, NO engine lights, light gas scent sometimes . What parts can cause such horrible fuel mileage???! Please help currently get 10 MPG , already changed spark plugs, ignition wires , fuel filter , air filter, regular oil changes, car starts everytime, fuel pump sound like its working
Sounds like you might have an oxygen sensor problem. Your catalytic converter(s) maybe defective or dirty. That in turn can dirty up the oxygen sensor. A defective oxygen sensor will send faulty info to the computer, interpreting the fumes as cold (even when the engine warms up). That causes the computer to adjust the fuel mixture to very rich, giving you poor gas mileage and the fuel smell. Hope it helps.
Posted on Mar 16, 2010
firing order and diagram for 1992 buick 3.8l engine
Click on the following Direct, Free Link:
http://autorepair.about.com/library/firing_orders/bl-fo-8337.htm
It has the Diagram and Firing Order for the 1992 Buick Regal 3.8L.
Let me know if this helped....Thanks for using FixYa.com!
Posted on Sep 25, 2010
Where is the turn signal flasher located on a 1992 Buick Regal?
I would get the owner's manual out of the glove box and look up fuse in the index. That will tell you where the fuse box is and often the turn signal and flasher units are plugged in there. With the signals on I would walk around the car and make sure the bulbs are all good.
Posted on Oct 01, 2010
There is a small 2 by 2 plastic box connected to my brake booster/master cylinder.It is bolted beside the intake manifold.I broke 1 plastic arm off when replacing the vacuum line.Could someone please identify this box so I can replace it.
First it is a junkyard or dealer item. I know what you need but don't know the name. Vacuum junction box is what I call it. There are many shapes and sizes. I call a dealer, tell them what I am looking for. They fax a picture and I pick out there number.
Posted on Jul 29, 2015
446 questions posted
Usually answered in minutes!
757 Questions
631 Questions
489 Questions
420 Questions
426 Questions