20 Most Recent 1998 GMC Sonoma - Page 6 Questions & Answers

did your washers work before this repair? If not check the washer pump on washer fill tank.

clutch safety switch bad. may be bad wire/fuse. shld be located on the clutch pedal normally kind of square to oblong box type switch abt inch and half long.you can unplug it, and place a jumper wire in the plug terminals and if it starts then you know its the switch (note: it works the same as a nuetral safety switch on an automatic)

they dont know how to drill and tap?

Take all of them out connect them to the flauta and put the igniton swicht to the on position to see if they r working

low beam of headlight most likely burnt

sounds like bad tires

when changing a compressor you drain both the old one and the new on then install the amount drained from the old one with new fluid to the replacement on

make sure u have 12v on both sides of the fuse and the new connector is wired correct and ck the ground u may have a bad wire 2 the pump i dont quite understand ur ? comletly if you dont have power 2 the pump the truck wouldnt run

The fuel feed line on most GM trucks is the 3/8line. The return line is the 5/16 line.